Water Creation F6001305CL, F6001305PL, F6001305AL, F6001303PL, F6001302CL User Manual

BEFORE YOU BEGIN

1) Shut off water supply.

2) Carefully inspect waste and supply tubing for signs of damage.

3) Replace waste or supply tubing if necessary

TOOLS AND MATERIALS

MODEL: F6-0013

INSTRUCTIONS

1) Apply tape or putty to both ends of hot and cold supply
nipples (8). Thread the nipples into risers (7).

2) Attach the rubber washer into riser nut (7), connect it with
faucet body.

3) Apply tape to the gooseneck spout thread (6) and screw into
faucet body.

4) Attach the rubber washer into cradle nut (4), connect it with
faucet body elbow (5).

5) Set the faucet onto tub and nipples go through the tub wall
holes.

6) Slid the metal washer (9) and install the lock nut (10) then
tighten with wrench.

7) Set the handles (11) on faucet body with screws.

8) Assemble the hand shower (1) (2) and hose (3) with rubber
washer, then to connect with cradle.

9) Connect the water supply lines to riser nipples.

10) Turn on main water supply and check all connections for
leaking.

COMPLETE INSTALLATION

Note: All nuts connections, hand tighten first then quarter turn

tighten by wrench. Don’t over tighten the nut.

Metal Lever

Porcelain Lever

TUB FAUCET INSTALLATION GUIDE