Water Creation EP60E0109, EB72D0612, EB72D0613, EP72D0509, EP72E0512 Installation Manual

...
STOP VALVE AND SUPPLY TUBE INSTALLATION
1. Apply Teon tape to thread of the pipe (2) and screw it with the stop valve
(3).
2. Slide the escutcheon (1) onto the pipe and apply the Teon tape to thread.
3. Screw stop valve to main water supply on wall. Use wrench to turn the valve
and let the outlet go up. (Don’t over turn the stop valve, it may damage the
MODEL: PS-0001
4. Close the stop valve and briey turn on the main water supply to check for
leaks.
5. Loosen the nut (5) and compression ring (4) from stop valve, take the supply
ube (6) and measure the length from stop valve to faucet valve, if
t
necessary to cut the extra length of tube.
6. Slide the nut (7) onto the supply tube and set the cone washer (8) at top.
7. Slide the nut (5) and compression ring (4) from boom of supply tube.
8. Aach the supply tube with faucet valve and stop valve. Tighten both nuts
with wrench. (This copper supply tube can be bent slightly for installao
9. Close the faucet valve and turn on the stop valve to check for leaks.
n )
8
7
6
5
4
3
2
1
P TRAP INSTALLATION GUIDE
MODEL: PS-0001
1. Remove horizontal pipe (2) and slip joint nut (3) from bo
2. Apply Teon tape to all exposed threads.
3. Slide the slip joint nut (3) and escutcheon (1) onto horizontal pipe. Then
insert the pipe into wall waste opening.
4. Remove slip joint nut (7) and washer (6) from bo le trap, to install it onto
drain tail piece.
5. A ach bo le trap to drain tail piece and hand ghten slip joint nut.
6. Align bo le trap with horizontal pipe and drain tail piece, at this point it
may be necessary to cut part of tail piece or part of horizontal pipe to
obtain proper alignment.
7. A er all components have been properly aligned, connect the bo le trap
and horizontal pipe with slip joint nut, making sure to set the washer (4)
before
8. Check for leaks by opening faucet and le ng water run for at least one
minute.
ghten the nut.
le trap (5).
Tail piece
7
6
3
4
5
2
1
Loading...