Water Creation DERBY36, MADISON72WBF, MADISON72WCF, MADISON72WF, MADISON60WCF User Manual

MODEL: F2-0009

TOOLS AND MATERIALS

LAVATORY FAUCET INSTALLATION GUIDE

BEFORE YOU BEGIN

1) Shut off water supply.

2) Carefully inspect waste and supply tubing for signs of damage.

3) Replace waste or supply tubing if n

ecessary

A) SPOUT INSTALLATION

1) Remove washer, lock nut and connect tee.

2) Apply plumbers’ putty or sealant.

3) Locate mounting hole and insert spout into deck or lavatory.

4) Screw and tighten washers, lock nut onto the shank and secure the spout

5) Insert pop-up rod into the spout.

6) Screw and tighten the connect tee to the shank.

7) Remove excessive plumbers’ putty or sealant

.

Basin Wrench

Pipe Wrench

Adjustable wrench

Screwdriver

Teflon Tape

Flexible Water
Supply Line

B) HANDLE VALVE INSTALLATION

1) Place lower plastic washer and lock nut over valve body.

2) Insert valve body from under the sink.

3) Place upper rubber washers and escutcheon on valve spindle.

4) Adjust position of valve body. Secure valve body with lock nut and escutcheon.

5) Place handle onto spindle.

6) Tighten handle

with screw.

HANDLE

ESCUTCHEON

METAL WASHER

LOCK NUT

CONNECT TEE

RUBBER WASHER

PLASTIC WASHER

LOCK NUT

VALVE BODY

C) FLEXIBLE HOSE INSTALLATION

1) Install flexible hoses onto hot and cold water outlets.

2) Secure hoses with wrench. Do not over tighten.

3) Connect flexible hoses to supply tee.

4) Circle the excessive part of hoses as shown in figure below.

END BODY OUTLET

MODEL: F2-0009

E) SUPPLY CONNECTION

1) Install lavatory according to manufacturer’s instructions.

2) Connect hoses (not provided) to angle stops.

3) Tighten all connections.

4) Flush out water for two minutes before connect hose to faucet valve.

(This act to avoid debris trapped the flow regulator)

*** VERY IMPORTANT ***

FLEX HOSE

D) DRAIN WASTE INSTALLATION

1) Install the drain body on the shank.

2) Secure pivot rod into pivot rod opening. (on the side of drain body)

3) Adjust the position of rod strap.

4) Secure rod strap to pivot rod with spring clip.

5) Locate end of pull-up rod of spout.

6) Insert pull-up rod into rod strap.

7) Secure pull-up rod with screw.

SCREW

ROD STRAP

SPRING CLIP

LOCK NUT

SUPPLY TEE

DRAIN FACE

FLANGE

F) INSTALLATION CHECKOUT

1) Ensure all connections are tightened properly.

2) Turn on main water supply.

3) Turn on and off cold and hot water respectively.

4) Turn on both hot and cold water and turn off. Check for leaks.

5) Remove the aerator cap and aerator. Check for debris. Clean of necessary.

6) Reinstall aerator.

PIVOT ROD

BALL WASHER

DRAIN BODY

COMPLETE INSTALLATION