Watec WAT-910BD Communications Manual
WAT-910BD SPI COMMUNICATION MANUAL(Digital Out)
WAT-910BD
SPI COMMUNICATION MANUAL(Digital Out)
Ver.1.0
Jul.01,2016
Watec Co.,Ltd.
WAT-910BD SPI COMMUNICATION MANUAL(Digital Out)
History
Ver. No.
Date
Changes
Remark
1.00
2016.07.01
First edition
- i -
WAT-910BD SPI COMMUNICATION MANUAL(Digital Out)
1. INTRODUCTION
2. LEGAL DISCLAIMER
3. OVERVIEW
4. SPI COMMUNICATION
5. DEGITAL OUTPUT FUNCTION SETTING
5.1 DIGITAL OUTPUT ON/OFF
5.2 DETAIL SETTINGS
5.2.1 CLOCK PHASE (CLK PHASE)
5.2.2 COLOR ID (COLOR ID)
5.2.3 OUTPUT DATA RANGE (DYC RANGE)
5.2.4 DIGITAL OUTPUT ON/OFF (DIGIT OUT)
5.3 DEGITAL OUTPUT GAIN (DIGITAL Y GAIN)
Contents
.................................... 1
.................................... 1
.................................... 1
.................................... 2
.................................... 4
.................................... 4
.................................... 8
- ii -
.................................... 5
.................................... 5
.................................... 6
.................................... 7
.................................... 8
WAT-910BD SPI COMMUNICATION MANUAL(Digital Out)
This manual is a supplement manual for using the digital output of the WAT-910BD.
Therefore, it is recommended that this manual is read in conjunction with the "WAT-910BD H / W manual".
Description requiring electrical knowledge needed to properly use the camera is included in the contents of this
document. Please read this document carefully, and use and/or install the camera after full understanding.
Under improper installation, it may cause serious damage to the connected equipment and the camera.
Please contact the distributor or dealer from which the WAT-910BD was purchased, if you do not understand the
installation, operation or safety instructions laid out in our manuals.
In addition, how to operate and install the camera, please refer "WAT-910BD Operation Manual" together with this
document.
Design and specifications are subject to change for improvement without notice.
Watec is not responsible for any inconvenience or damages to the video and monitoring recording equipment
caused by misuse, mis-operation or improper wiring of our equipment.
Technical information contained herein is for reference only and does not convey any license by any implication
or otherwise under any intellectual property right or other right of Watec or third parties.
Watec does not assume responsibility for any right infringements arising out of the use of this information.
This document describes how to set and to adjust the the digital output function by using the SPI communication
function of WAT-910BD.
Please refer to Chapter 6 of "WAT-910BD H / W manual" to know that how to use the SPI communication function.
About the video format of the digital output, please refer to Chapter 5 of "WAT-910BD H / W Manual".
2. LEGAL DISCLAIMER
1. INTRODUCTION
3. OVERVIEW
- 1 -
Loading...