Page 1
1 10V AC / 240V AC
Microphone*
QUICK CONNECTION GUIDE
Connecting Your PNT DVR
Smart Phone*
Router*
LAN / WAN
Free DDNS
www.dvrid.com
IE/Client for Windows or MAC Client for OSX
720P/1080P HDMI*
Simultaneous Display
12 Volts Power
Note:
The connection diagram is using 8CH system, other systems will vary.
PNT Series DVRs use RG59 cables up to 500m.
It is also compatible with most UTP baluns.
Cable distance is dependent on cable quality.
* Not included/sold separately.
WatchNET Products are subject to continuous changes and
improvements, information on this document is subjected to
change without prior notice.
Speaker*
Package Contents:
DVR (X1)
USB Mouse
Cameras Software CD (X1) Quick Start Guide (X2) Mouse (X1) Remote Control (X1)
KIT dependent
Power
ON/OFF
720P/1080P HDMI*
Simultaneous Display
2018 WatchNET Inc.
©
www.watchnetinc.com
All Rights Reserved
Camera power supplies and cable not included.
12V 500mA Power Supply required per camera.
Power Adaptor (X1) Ethernet Cable (X1) Power Cable (X1) Mouse Pad (X1)
Page 2
EASY START-UP WIZARD
The system will go through Device Initialization and Startup Wizard after powering up for the first time. The system will prompt to set the system’s language, video standard, system login information as well as the system’s general settings.
Please take note of the new admin password as it can only be reset by email and security questions. If password cannot be recovered, system has to go thru the RMA process and ship to the manufacturer for factory default.
Device Initialization:
Step
Language and Video Standard
1
Step
Setup new password - (Please take note of the new password since
tech support can’t resset the password)
2
Step
Unlock pattern can be used to Login.
3
Step
Email and Security Questions setup.
Please make sure to setup these settings for password recovery.
4
Step
Welcome Screen click Next.
1
Step
Configure the system’s time and date settings to match the
location’s time zone. Click Next to proceed.
2
Step
Change the default TCP/IP settings to match the local network.
Click the Test button to do a quick test on the configuration.
Click Next to proceed.
3
Startup Wizard:
Step
Enable P2P for remote viewing as required.
The status will say “online” if the network
settings are correct. Click Next to proceed.
4
Step
Configure the video recording schedule as required.
Click Back to return to previous step or Next to proceed.
Then click Finished.
5
Loading...