Page 1
QUICK CONNECTION GUIDE
Connecting Your ENM-04/08 POE
Package Contents:
LAN / WAN
Free DDNS
www.dvrid.com
NVR (X1) Cameras Remote Control (x1) Software CD (X1) Mouse (X1) Power Adaptor (X1) E thernet Cable (X1)
PoE
48 Volts Power
Router*
Microphone*
Speaker*
Smart Phone*
720P/1080P VGA*
Simultaneous Display
IE / Client for Windows or MAC Client for OSX
PoE IP Cameras
USB Mouse
WatchNET Products are subject to continuous changes and
improvements, information on this document is subjected to
change without prior notice.
2015 WatchNET Inc. © All Rights Reserved
110V AC / 240V AC
720P/1080P HDMI*
Simultaneous Display
LAN
Typical 16 Camera connection
with built-in 8 Port POE NVR & 16 Port Switch
ENM 16 POE*
POE Cameras
Strobe lamp*
NOTE:
1. External 12 or 16 Port POE Switch is needed to connect the additional 8 cameras.
(If using regular switch, the cameras must have 12V 1Amp Power Source connected)
2. Launch the Config tool from the software CD and assign IP Address to cameras to suite the
local LAN configuration.
3. Please see hardware manual on the software CD for more instructions.
NOTE
:
Cameras included only
in KIT Models and may vary from
KIT Model numbers
* Not included/sold separately.
Power Cable (X1) Quick Start Guide Mouse Pad (X1)
ENM-04 does not have Alarm IN / OUT
Power
12V
Page 2
EASY START-UP WIZARD
When first booting up the NVR, Password change Wizard will initiate.
Put the old password "1234" and create a new password.
Click "OK" to continue.
NOTE: Please remember and store your password, manufaturer will not be responsible
for lost paswords.
Cancel to exit and keep the old password.
Use the mouse to navigate thru the setup.
Login
Systems Default
Username: admin
Password: 1234
System Settings
Adjust the time and date. Click "Save" before moving to the next step.
Network
Change the default network to match the local network. Ask the network
administrator for the proper IP address, Gateway and Subnet Mask.
Click Next Step when done
Save Date & Time
adjustments
Remote Device (Connecting IP Cameras)
MPIX cameras will auto-enroll, will be assigned
an IP and camera number Defaults:
Cam 1 will be assigned to 10.1.1.65
Cam 2 will be assigned to 10.1.1.66
Cam 3 will be assigned to 10.1.1.67
Cam 4 will be assigned to 10.1.1.68
Set Recording Schedule
User can choose what the NVR
records. Normal, Alarm, Motion
or all events
By default all NVRs are set to
record motion detection 24/7
Camera Number
Hours of the day
Days of the week
Recording
Color Codes
Click Next Step and Close the Wizard.
Now the system is setup and ready for recording.
1
Step
2
Step
3
Step
4
Step
5
Step
www.watchnetinc.com
Loading...