Waste King 2600 Installation Manual

Part No. 17384

Revised: January 2009

Super Pop Maxx

Instruction Manual

Model 2600

Super Pop Maxx

SAFETY PRECAUTIONS

Model #2600

2

Super Pop Maxx

Forward

This manual covers the 16oz. Super Pop Maxx Popcorn Machine, model number 2600.

Installation Instructions

Inspection of Shipment:

Unpack all cartons and check thoroughly for any damage that may have occurred during transit.
Damage claims should be filed immediately with the transportation company. Gold Medal is not
responsible for damage that occurs in transit.

Setup:

Your new Super Pop Maxx Popcorn Machine is completely assembled and tested at the factory.
Remove all packing material and tape before starting operation.

Electrical Requirements:

The following power supply must be provided:

Model No. 2600: 1660Watts, 120 VAC, 13.8 Amps, 60 Hz.

Your electrician must furnish sufficient current for proper machine operation. We recommend this
popper be on a dedicated and circuit protected line. Failure to wire properly will void the warranty
and can result in damage to the heat elements, light, motor and etc.

It is Gold Medal Products Company’s recommendation that this machine be plugged directly into a
wall outlet. The use of extension cords is not recommended due to safety reasons and the popper’s
performance will be sacrificed/reduced.

Before You Plug In Machine:

1. Make sure that the wall outlet can accept the three (3) prong grounded plug on the power supply
cord.

2. The wall outlet must have the proper polarity. If in doubt, have a competent electrician inspect the
outlet and correct if necessary.

3. DO NOT use a three (3) prong grounded to two (2) prong un-grounded adapter.

Model #2600

3

Super Pop Maxx

r

Operating Instructions

Controls and Their Functions

Light & Warmer Switch

This switch operates the overhead light and corn deck freshener heat element.

Kettle Motor Switch

This switch operates the popcorn agitator shaft. This switch must be ON at all times when
popcorn (popped and un-popped) is present in the kettle.

Kettle Heat Switch

This switch turns on the heat element located in the popcorn kettle.

Kettle Heat

Switch

Kettle Moto

Switch

Lights/Warmer

Switch

Model #2600

4

Super Pop Maxx

Amount of Popcorn and Oil:

The Super Pop Maxx is equipped with a sixteen ounce corn measure cup. Gold Medal Products
Company recommends the use of flavored and colored coconut oil. Coconut oil does not leave
black deposits in the kettle like other oils.

Corn Charge: 16 Oz. (473 ml)
Oil Charge: 4-5 ounces
Flavacol (Salt): 1 ½ Tablespoon (20 cc) (Use the supplied Salt Scoop)

Popping Instructions:

1. Turn both the KETTLE HEAT and KETTLE STIR MOTOR switches ON.

2. Test pop three (3) kernels of corn and one ounce (1 Oz.) of popping oil. When the kernels pop,
the kettle is ready for use.

3. Load both a full corn/oil charge and Flavacol Seasoning Salt into the kettle. Close the lids.

4. When the corn has finished popping, gently dump the kettle.

5. Repeat the cycle, starting with step number 3, until the desired amount of popcorn has been
achieved. Always pop 3 to 5 consecutive batches for the best popcorn.

On the final kettle of corn, it is a good idea to turn the KETTLE HEAT switch OFF just as the lids are
forced open by the popping corn. This procedure saves electricity since the kettle has plenty of heat
and eliminates smoke/odor from any oil residue that remains after you have stopped popping.

Model #2600

5