Wasp Barcode Technologies WWS550BT Users Manual

User’sGuide

WAS P



WirelessBarcodeScanner

WWS550

GETTING CONNECTED PINCODE SETUP

There are two modes of wireless communication:

. E042$

STEP 1

. E032$

*.E042$*

1. Press the trigger for 1 second to activate the scanner.

2. Scan [DISCONNECT]

3. Scan [BT mode - SPP]; the scanner will emit 10 beeps.

4. Select “Wireless Scanner” from discovered device list.
The default pincode is “1234”.

5. Open serial communication software with com port
(see Device Manager) properly set up.

6. The scanner will beep twice to verify the connection.

. E043$

*.E043$*

1. Press the trigger for 1 second to activate the scanner.

2. Scan [DISCONNECT]

3. Scan [BT mode - HID]; the scanner will emit 11 beeps.

4. Select “Wireless Scanner” from discovered device list.

5. The Bluetooth application may prompt you to scan
a pincode(see PINCODE SETUP section) it generated.

6. The scanner will beep twice to verify the connection.

. E031$

*.E031$*

- 7 -- 8 -

BT mode - SPP Pincode Start

BT mode - HID

Disconnect

*.E032$*

STEP 2

Scan numeric barcodes (see NUMERIC BARCODES section

on the next pages)

by the Bluetooth application.

STEP 3

based on the pincode generated

$TX

Enter

*$TX*

STEP 4

Pincode Stop

. E033$

*.E033$*