PW2C
WIDE BODY FRONT LOADED WAREWASHER
C/W HEAT RECOVERY UNIT
OPERATOR MANUAL
21/11/2018 Washtech PW2C Operator Manual 2
Warnings
Before installation and commissioning, you must read the safety instructions and
warnings carefully and all the warning labels attached to the equipment.
Equipment contains dangerous voltages and can be hazardous if installed or
operated incorrectly. Non-compliance with warnings or failure to follow the
instructions contained in this manual can result in loss of life, severe personal
injury or serious damage to property.
Before installation or repair, you must read the instructions and warnings
carefully and all the warning labels attached to the equipment.
All service/repair work must be carried out by qualified personnel only and
ensure compliance with all local codes and standards including AS/NZS 3500.1.
Important Information
Failure to comply (even partially) with the instructions given in this manual will
invalidate the product warranty and relieves the manufacturer of any
responsibility.
The alteration of machine operation, design or the replacement of parts not
approved by the manufacturer may void warranties and approvals.
This machine is intended for commercial use only.
The machine is designed solely for cleaning crockery (porcelain, glass, ceramic,
temperature-resistant plastics, stainless steel or similar) from the food industry.
This machine is not intended for washing: containers that do not come into
contact with foodstuffs, animals, textiles or foodstuffs intended for further
consumption.
We have checked that the contents of this document correspond to the model described. There
may be discrepancies nevertheless, and no guarantee can be given that they are completely
identical. The information contained in this document is reviewed regularly and any necessary
changes will be included in the next edition. We welcome suggestions for improvement.
Document subject to change without prior notice.
Information supplied in this manual is copyright. No part of this work may be reproduced or
copied in any form or by any means, electronic or mechanical without the express permission of
the author / publisher.
21/11/2018 Washtech PW2C Operator Manual 3
Contents
2. Warning
3. Contents
4. Safety Instructions
5. Installation Diagram
6. Installation Instructions
8. Installation Checklist
9. Installation Troubleshooting
10. Operator Use Guide
11. Operator Troubleshooting
12. Schematic diagram
13. Accessories
14. Notes
Contents
21/11/2018 Washtech PW2C Operator Manual 4
Installation
• Use qualified, skilled personnel.
• Follow installation instructions.
• Connect to correct voltage and supply current.
• Provide fully accessible Electrical Isolation Switch & water supply valves.
Training and Supervision
• Read and Understand the Operating instructions and train all staff.
• This appliance must not be operated by children or infirm persons.
• Machine panels must only be removed by suitably qualified and trained personnel – internal
hazards include live electrics and very hot surfaces.
• No part of this appliance is not intended for use as a stepladder – do not stand on open door.
Hot Surfaces
• Some surfaces may be hot or very hot.
Chemicals
• Commercial dishwashing detergents are hazardous – handle with care.
• Read and follow the safety information found on the labels of detergent containers and
Material Safety Data Sheets.
• Use protective eyewear and clothing if decanting containers.
Hot Water
• Do not put hands in wash water which may be over 60°C and contain hazardous caustic
detergent.
• Rinse water can be over 90°C.
• Door safety switches are designed for emergency use only.
Cleaning
• Do not hose down the machine or splash water over the exterior.
• Watch for broken glass etc. when cleaning the inside of the machine.
Warnings
Equipment contains dangerous voltages and can be hazardous if installed or
operated incorrectly. Non-compliance with Warnings or failure to follow the
instructions contained in this manual can result in loss of life, severe personal
injury or serious damage to property.
Installation and servicing must be carried out by a suitably qualified person in
compliance with all local codes and standards including AS/NZS 3500.1.
Safety Instructions
21/11/2018 Washtech PW2C Operator Manual 5
Installation Diagram
PW2C Installation Diagram
• Part #: WPW20021
• Date: 25/09/2018
• Version: 3-C
Loading...