Warrior NERF BAR STEP PLATES User Manual

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior Products, Inc.

16850 SW Upper Boones Ferry Rd

Ste. A

Durham, OR 97224

Phone [phone]

Fax [phone]

[e-mail]

NERF BAR STEP PLATES

DIAMOND PLATE or STEEL

All “Nerf Bar Step Plates” are designed to be placed over the existing metal Nerf bar surface.

1) Be sure that any Nerf Bar metal surfaces are repainted if needed.

2) Place the Nerf Bar Step Plate onto the Nerf Bar and use it to determine where you want
to place your mounting holes. You will usually want to locate the center of the step near
the front of the front seat since this is where most people step to enter the vehicle. Mark
the mounting locations with a felt pen or other marker and remove for ease of drilling. If
you are covering rust or damaged areas, try not to locate any mounting holes in these
areas.

3) If using “pop” rivets to attach your step plates, you will need to secure “pop” rivets, a
drill, a drill bit to fit the size of your rivets, and a “pop” rivet tool. Drill mounting holes
using the drill bit, and be sure to use safety glasses to protect your eyes. (Rivets Not
Included)

4) Install the step plates using the “pop” rivets. If you prefer you can use self- tapping bolts
to install the step plates.

CONGRATULATIONS! You have finished your installation. Enjoy your new Warrior Nerf
Bar Step Plate and be sure to look for other quality Warrior Products for your vehicle.