Warrior Dashboard Overlay User Manual

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone: [phone]
Fax: [phone]

[e-mail]
www.warriorproducts.com

07-10 JK Dashboard Overlay

Installation Instructions

Installation of these is quite simple and can be done with a handheld screwdriver, but a powered screwdriver
makes it much easier. You should have 4 panel pieces and 16 Phillips head stainless screws.

INSTALLATION

1. Start at the bottom and work your way up. Hold your lowest panel in place so that it is lined up correctly
around the holes for your 12v outlets and the buttons between. You can drive the screws in now with the
panels in place, or mark them, set the panel aside and run the screws in where you marked.

2. Once you have the bottom panel in place, repeat the process for the next 3 panels. Again, be sure you
are working your way up from the bottom.

3. Once all 4 panels are in place, your installation is complete.

This is the standard installation for this part. If you would prefer, you can try to install them with two sided tape.
Your results in this method may not be the best as the dash is curved and the flat panels are pulled in to match
the curve by the screws.

Thanks for purchasing Warrior Products! Please see our other Jeep accessories at www.warriorproducts.com

If you need further assistance installing your product, please contact us by email at [e-mail]
or call us at [phone].