Warrior 897 User Manual

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior Products, Inc.

16850 SW Upper Boones Ferry Rd

Ste. A

Durham, OR 97224

Phone [phone]

Fax [phone]

[e-mail]

STEERING BOX BRACE

INSTALLATION INSTRUCTIONS

WAR 895/897

1. Remove the rear bolt from the spring hanger on the passenger side.

2. Bolt the cross bar steering brace to the frame rail with the bolts provided. Use one of the 1 _”

bolts through the existing frame bracket, (bolt, lock washer, and flat washer). Use one of the 1
_” bolts through the frame’s existing hole, (bolt, lock washer, and flat washer). Do not tighten
at this time.

3. Install “C” brackets around the bottom of the steering bracket using the bolts and lock nuts
provided. Make sure the Pitman Arm has clearance to turn without interference from the
bracket.

4. Torque bolts on the frame first to 50 ft lbs. Then torque bolts around the steering box to 50 ft
lbs.

5. After a test drive, verify that all of the bolts are tight.

If you need further assistance installing your product, please contact us by email at

[e-mail] or call us at [phone].

THANK YOU FOR PURCHASING WARRIOR PRODUCTS