Warrior 893 User Manual

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior Products, Inc.

16850 SW Upper Boones Ferry Rd

Ste. A

Durham, OR 97224

Phone [phone]

Fax [phone]

[e-mail]

STEERING BOX BRACE

INSTALLATION INSTRUCTIONS

WAR 893

Your new steering box brace bolts between steering box neck, next to the Pitman Arm and the
opposite side frame rail.

1. Bolt the flat plate with 4 holes, provided with kit, to the bottom of the

steering box, above the Pitman Arm. The new bolts provided must have
lock tight applied to the threads. This is mandatory. The “U” opening faces
towards the drivers side. Tighten all four bolts.

2. Install complete cross bar using the four (4) self tapping screws to the frame.

Leave bolt on steering box tube loose at steering box until the 4 self tapping screws have
been installed. The screws can self drill or, for ease of installation, a pilot hole of 9/32” can
be drilled.

3. Tighten all bolts. Caution: do not over tighten self tapping screws.

4. After a test drive, verify that all bolts are tight.

If you need further assistance installing your product, please contact us by email at

[e-mail] or call us at [phone].

THANK YOU FOR PURCHASING WARRIOR PRODUCTS