Warrior 834 User Manual

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior Products, Inc.

16850 SW Upper Boones Ferry Rd

Ste. A

Durham, OR 97224

Phone [phone]

Fax [phone]

[e-mail]

ADVENTURE RACK

INSTALLATION INSTRUCTIONS

WAR 834

(Note: Modification to the plastic hinge covers is required on 2004 & UP models)

1. Remove spare tire from the rear of the tailgate.

2. On the latch side of the tailgate (see figure "A") drill 3/8" hole 1/2" from the side & 1/2" from the bottom of the

tailgate.

3. Drill second 3/8" hole 1/2" from the side and 14 3/8" from the bottom of the tailgate. (see figure "A")

4. Install driver's side leg. Bolts are installed from inside the tailgate pointing out. (see figure "B") Top bolt has a

small flat washer next to bolt head (provided). Bottom bolt has large flat washer. Do not tighten bolts at this time.

5. On the passenger side, if the hinges have a plastic cover it either needs to be notched or removed entirely. In order
for the bolt to be tightened, the leg needs to be flush against the metal. Open the tailgate and drill a 5/16" hole into
both the upper and lower tailgate hinges, on the body side to the right of the tailgate. The holes should measure 35
7/16" from the center of the holes drilled in the tailgate for the driver’s side leg. (see Figure A) Countersink
inside of Hinge for tapered cap screw. Screw will point out. Only countersink deep enough so that tailgate will
close. Do not go too deep! Some grinding of the hinge may be necessary so the bolt will sit flat and the tailgate
will close.

6. Install passenger side leg onto the tailgate hinge (tailgate door must be open) using the tapered cap screws
provided. Do not tighten the bolts at this time.

7. Install basket on top of the legs.

8. Install lower brackets to bottom of legs using quick release pins. Mark holes for drilling on the vehicle body

where the bracket rests against the body.

9. Remove brackets and drill 1/8" hole where marked. Re-install bracket using quick release pins before securing
brackets with self tapping screws.

10. Tighten all bolts and make sure the Rack is securely attached to the rear of the vehicle. If you have bolted the
rack only to your tailgate, a 50lb. Weight limit is advised.

If you need further assistance installing your product, please contact us by email at [e-mail] or call
us at [phone].

THANK YOU FOR PURCHASING WARRIOR PRODUCTS