Warrior 580 User Manual

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior Products, Inc.

16850 SW Upper Boones Ferry Rd

Ste. A

Durham, OR 97224

Phone [phone]

Fax [phone]

[e-mail]

ROCK CRAWLER BUMPER

WITH RECEIVER

INSTALLATION INSTRUCTIONS

WAR 575- 576- 577- 580

1. Remove your existing bumper, or bumperettes, from your vehicle.

2. Install new bumper using the 7/16” lock nuts and washers provided. Washers

should be placed between the nut and the frame. On some models the inside bolt
holes are not drilled. You will need to align the bumper and drill holes 15/32” or
_”. The gas tank may or may not need to be lower to install the inside nuts on to
the bolts. It is difficult but can be done with out lowering the tank.

3. After initial test drive, check all bolts for tightness. You should check all bolts
for tightness each time before using the receiver hitch for towing.

Enjoy your new bumper!

If you need further assistance installing your product, please contact us by email at

[e-mail] or call us at [phone].

THANK YOU FOR PURCHASING WARRIOR PRODUCTS