Warrior 560 User Manual

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior Products, Inc.

16850 SW Upper Boones Ferry Rd

Ste. A

Durham, OR 97224

Phone [phone]

Fax [phone]

[e-mail]

CHEROKEE BUMPER

INSTALLATION INSTRUCTIONS

560 SERIES

Phase 1: Bumper Removal

1. Start by unbolting your bumper on each side. There are 3 bolts in a triangular pattern that hold the bumper in place.

Use a 15mm wrench or socket to remove them. If you have factory tow hooks, there will be an additional TORX
head bolt further back on the frame rail holding the brackets in place, as well as a bracket on the bottom side of the
frame rail.

2. The bumper should now be loose. On the passenger side, there should be a plastic vacuum canister bolted to the

bumper from the bottom. Remove the bolts and pull the bumper off of the Jeep. The canister can hang loose while
you install your bumper.

Phase 2: Bumper Installation

1. Slide your factory bumper, or new aftermarket bumper into place

2. Using the 3 bolts removed in Phase 1; attach the bumper to the vehicle. Thread all 6 bolts before tightening any of

them. Be sure to align the bumper so it is sitting straight on the vehicle as there is some play in the holes.

3. The last part of the installation is to re-attach your vacuum canister. You can either drill holes in the bumper to hold

it, or many people choose to relocate it into the engine bay.

Installation is completed. Visit www.warriorproducts.com to see more of our Jeep Cherokee Accessories.

If you need further assistance installing your product, please contact us by email at [e-mail] or call
us at [phone].

THANK YOU FOR PURCHASING WARRIOR PRODUCTS