Warrior 4403-RJR User Manual

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone: [phone]
Fax: [phone]

[e-mail]
www.warriorproducts.com

HAND GRIP

Installation Instructions

Warrior 4403 / RJR 44CG03B

1. Open all Velcro attachments

2. Remove detachable handle and lay out flat

3. Wrap main body of Hand Grip onto roll bar and secure with Velcro straps

4. Attach grab handle at appropriate angle (this will vary depending on how and where you have

mounted the Hand Grip)

5. If you have installed your Hand Grip on an unpadded roll bar you may have to apply a non-skid

material to your roll bar to avoid slippage (non-skid tape or self adhesive rubber pads are available at
your local hardware store)

Hand Grip is designed as an off-road convenience product only and is not an approved safety
device or mount. Off-roading can be dangerous and the manufacturer of Hand Grip (Warrior
Products) assumes no liability for injury, property damage or loss of life.

Thank you for purchasing Warrior Products.