Warrior 4402 User Manual

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone: [phone]
Fax: [phone]

[e-mail]
www.warriorproducts.com

SUBJECT: Part #4402 Combo Hand Grip Fire Extinguisher Rollbar Mount Installation Instructions

1. Before starting the installation, separate the safety strap and grab handle from the main portion of the
combo grip. Set these pieces aside for later use.

2. Open all 4 Velcro straps and lay the grip out flat with all Velcro face down. This will be the side of the
combo grip that will go against the rollbar.

3. Lay the combo grip over the rollbar and attach by wrapping the outermost 1” Velcro straps around the
rollbar and then back onto the mount. Follow Figure 1 through Figure 4

Figure 1 Figure 2

Figure 3 Figure 4

4. Next, slightly loosen the straps and rotate the grip on the rollbar until the open side of the grip is located
on the rollbar where you would like the fire extinguisher to sit. Retighten straps.

5. Locate the grab handle portion of the grip that you set aside earlier in the install. Wrap it over the rollbar
Velcro facing toward the combo grip. Rotate it so that is located in the orientation you’d like on the rollbar
and press the hang grip onto the Velcro of the main combo grip piece. Wrap the handle grip into its own
Velcro to finish the hand grip installation. Follow Figure 5 through Figure 7.

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone: [phone]
Fax: [phone]

[e-mail]
www.warriorproducts.com

Figure 5 Figure 6 Figure 7

6. Next, install the fire extinguisher. Begin by sliding the extinguisher through the closed loops on the
combo grip.

7. Locate your safety strap. Use this strap to secure the top of the extinguisher to the first closed loop on
the grip.