Warrior 3915 User Manual

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior Products, Inc.

16850 SW Upper Boones Ferry Rd

Ste. A

Durham, OR 97224

Phone [phone]

Fax [phone]

[e-mail]

TOYOTA FJ CRUISER REAR CORNER

GUARDS

INSTALLATION INSTRUCTIONS

WAR 3915

Installation:

1. Since the factory rear bumper and corners are one formed piece, the factory bumper needs to be
modified before the Warrior rear corner guards can be installed. This involves irreversible
removal of the plastic corner pieces.

2. Locate the seam between the corners and the top of the
bumpers caps. Utilizing a rotary tool with a cut-off wheel or a
box knife (a small length of hack-saw blade also works well),
separate the corners from the bumper leaving behind about
3/8” to 1/2” of material to serve as a flange that the bottom
edge of the new corners will set against.

3. After the cuts have been made, remove the plastic corners by
pulling the bottom edges out and up. They should pop off at the
top of the plastic internal structure attached to the body. Now
remove the plastic internal structure and any plastic inserts at
this time.

4. Remove the two rear-most fender screws so that
the Warrior corner guard brackets can easily slip
between the body and the rear plastic tabs of the
factory fender.

5. There is a series of square holes in the body of
the vehicle that we will be utilizing for the
brackets installation. If any factory inserts
remain after removing the plastic corners and
their associated parts, remove them now. Snap
five of the square plastic inserts per side into the
square factory holes shown in the image to the
left.

6. Align the brackets over the square plastic inserts and attach them with the _” x 3/4” hex bolts.
There are _” flat-washers provided for the rear plastic fender tabs. Place the washers on the bolts
and set them through the fender tabs and corner guard brackets and into the square plastic inserts.
Do not over-tighten as you risk stripping out the plastic inserts.

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior Products, Inc.

16850 SW Upper Boones Ferry Rd

Ste. A

Durham, OR 97224

Phone [phone]

Fax [phone]

[e-mail]

7. There are two small holes per side that will need to be drilled into
the body to attach the ends of the brackets where no factory holes
are provided. Locate these positions and use a 1/8” drill bit then
attach the ends of the brackets using the #10 x _” self-tapping
screws provided.

8. Once the Warrior corner guard brackets have been installed, snap
the square plastic inserts into the square holes on the corner guard
brackets. (six per side)

9. There is a length of rubber fender trim provided to affix trim along
the top and fender-side of each corner guard. For tight corners, cut
a small ‘wedge shape’ from the front and rear sides to allow the
trim to lay flat.

10. Hold the corner guards up to the brackets and visually locate the inserts through the holes in the
corner guards. Use the 6mm x 16mm counter-sunk screws provided to attach the corner guards to
the brackets. Once again, take care not to over-tighten as you risk stripping out the plastic inserts.
Finally, confirm that the installed corner guards do not interfere with operation of the tail gate.
Your Warrior Products corner guards are now installed.

If you need further assistance installing your product, please contact us by email at

[e-mail] or call us at [phone].

THANK YOU FOR PURCHASING WARRIOR PRODUCTS