Warrior 3516 User Manual

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior Products, Inc.

16850 SW Upper Boones Ferry Rd

Ste. A

Durham, OR 97224

Phone [phone]

Fax [phone]

[e-mail]

3516 ‘10-’13 FJC Warrior Front Bumper Skidplate

Installation Instructions

NOTE: This Skidplate is only compatible with the 3520 & 3530 Warrior FJC Front Bumper.

KIT CONTENTS:

Description

Qty

Description

Qty

Front Bumper Skidplate

1

5/16” Hex Nut

5

5/16” Stainless Steel Button Head Screw

5

5/16” Lock Washer

5

INSTALLATION:

1. Locate and remove the four 12mm bolts that affix the factory skidplate to the front and secondary cross

members. Pivot the factory skidplate off the two forward ‘hooks’ and temporarily set aside.

2. Looking at the front cross member of the FJ you

should now see two 14mm bolts. Remove these
two bolts and set aside. (Fig. 1)

3. Set the Warrior skidplate into place with the

lower two tabs through the narrow sheet metal
structure where you accessed the 14mm bolts.
The five holes along the top edge of the skid
plate should also line up with the lower holes in
the Warrior FJC front bumper. Loosely thread
the 5/16” screws with the lock washers and nuts
on the inside through the bumper and top edge
of the skid plate and the factory 14mm bolts
through the skidplate lower tabs.

Note: On some early versions of the 3520­3530 Warrior front bumper there may be
some clearance issues with the two
outermost mounting holes and the bumpers’ inner winch plate support structure. Utilizing a cut-off tool to
trim the two outermost 5/16” screws shorter will alleviate this issue.

4. Once the skidplate has been positioned and all bolts have been threaded, tighten all hardware. Take the factory

skidplate and reinstall onto the front and secondary cross members with the factory 12mm bolts.

5. Double check fitment and that all hardware is tight. The installation of your 3516 FJC Warrior Front Bumper

Skidplate is now complete.

THANK YOU FOR PURCHASING WARRIOR PRODUCTS

If you need further assistance installing your product, please contact us by email at [e-mail] or call us at [phone].