Warrior 3515 User Manual

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior Products, Inc.

16850 SW Upper Boones Ferry Rd

Ste. A

Durham, OR 97224

Phone [phone]

Fax [phone]

[e-mail]

3515 FJC Warrior Front Bumper Skidplate

Installation Instructions

NOTE: This Skidplate is only compatible with the 3520 & 3530 Warrior FJC Front Bumper.

KIT CONTENTS:

Description

Qty

Description

Qty

Front Bumper Skidplate

1

_ Lock Washers

5

8mm x 20mm Stainless Steel Button Head Screws

7

_ USS Flat Washers

2

8mm Nuts

5

INSTALLATION:

1. Locate and remove the two bolts that affix the front edge of the factory skidplate to the front cross member.

You may reuse these bolts or use the hardware provided with the Warrior skidplate.

2. Set the Warrior skidplate into place with the bumper side edge set inside the front bumper. Loosely thread the

hardware through both the bumper and the skidplate.

Note: On some early versions of the Warrior front bumper there may be some clearance issues with the two
outermost mounting holes and the bumpers’ inner winch plate support structure. Utilizing a cut-off tool to
cut the two outmost 8mm x 20mm screws shorter will alleviate this issue.

3. Push the skidplate into place so that the two lower mounting tabs set inside of the depressions in the front edge

of the factory skidplate. Thread the remaining hardware into these two slots utilizing the _ flat washers. If the
slots in the skidplate do not line up with the holes in the front cross member, check to make sure the front
bumper is centered on the frame mount studs. Make any necessary adjustments then tighten all bolts.

4. The installation of your FJC Warrior Front Bumper Skidplate is now finished.

THANK YOU FOR PURCHASING WARRIOR PRODUCTS

If you need further assistance installing your product, please contact us by email at [e-mail] or call us at [phone].