Warrior 201 User Manual

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior Products, Inc.

16850 SW Upper Boones Ferry Rd

Ste. A

Durham, OR 97224

Phone [phone]

Fax [phone]

[e-mail]

201 & 202 Baja Tire Carrier

INSTALLATION INSTRUCTIONS

NOTE: This product is designed to be installed universally into any truck bed or flat surface

Parts List

A – Upper Leg Support Plate

B/C – Support Legs (left/right)

D/E – Support Leg Mount Plates

F- Main Leg Mount Plate
G – Under Bed Reinforcing Plates

H – Tire Support Shaft

I – Wheel Grip Plate

J – Main Handle
K – Main Leg

L – Release Handle

Hardware List

Qty 24 – 3/8” Locking Nut

Qty 1 – 3/8” x 2” Allen Bolt

Qty 2 – 7/16” Nylock Nut

Qty 2 – 7/16” x _” Socket Allen Bolt
Qty 11 – 3/8” x 1” Allen Bolt

Qty 12 – 3/8” x 2” Carriage Bolt

Qty 1 – 5/8” x 2” Carriage Bolt

Installation will begin on page 2

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior Products, Inc.

16850 SW Upper Boones Ferry Rd

Ste. A

Durham, OR 97224

Phone [phone]

Fax [phone]

[e-mail]

PRE-ASSEMBLY: The first portion of this assembly can be done on a workbench. You will not need to be at your vehicle
to complete this section.

1. Begin by locating the main leg mount plate (F) and the main leg (K). Slide the 5/8” carriage bolt through the
square portion of the hole in part F so that the carriage bolt is pointing straight up. Set the main leg (K) over the
carriage bolt. Use wingnut (L) to tighten the plate to the leg. See illustration.

2. Next, the support legs (B/C) will be bolted to the main leg (K). There are
three holes near the top of the main leg that these will bolt to. The support
legs should sit inside of the main leg. Use six of your 1” allen bolts and lock
nuts to attach the supports to the main. Leave the bolts loose, you cannot
tighten the entire assembly until all parts are together at the end of this pre­assembly.

3. Next, locate the upper leg support plate (A). This will bolt onto the top of the
support legs using four of the 1” allen head bolts and lock nuts. Make sure
when you install it that the bent tab at the top points up. Again, leave bolts
loose until final assembly.

4. Install the tire support shaft (H) onto the assembly. This piece will slide down the inside of the main leg until the
top hole in the threaded portion lines up with the top hole in the main leg. Use your 2” long allen bolt to bolt thru
the main leg, the tire support shaft, and the vertical tab in the support leg top plate. Use your remaining 1” long
allen bolt through the bottom hole in the main leg where the tire support shaft aligns with it.