Warrior 1520 User Manual

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior Products, Inc.

16850 SW Upper Boones Ferry Rd

Ste. A

Durham, OR 97224

Phone [phone]

Fax [phone]

[e-mail]

HALF DOOR WINDSHIELD BRACKETS

INSTALLATION INSTRUCTIONS

WAR 1520

Congratulations on your purchase of a quality Warrior Products part. Please read the instruction carefully
before beginning.

1. Your diamond plate half doors must be mounted

onto your Jeep in order to install the brackets
properly. The top window portion of your soft
top door must be positioned as you want it to fit
above your aluminum half door.

2. With the window in the proper position, slide

shorter mounting bracket marked #1 onto the
forward window mounting post. The other short
bracket with no marking is the middle bracket. Slide this bracket onto the middle post. With the
bracket flanges pointing towards the rear of the vehicle, mark through the bolt holes onto the half door
for drilling.

3. Follow the same procedure for the rear bracket that fits adjacent to the door handle, only with the

bracket flange pointing towards the front of the vehicle.

4. Drill six _” holes where you have made your marks and install the brackets using the _” x _” bolts

provided. The bolts should be installed with the bolt heads on the outside of the door. Be sure the bolts
are tightened securely.

5. Slide your soft top window mounting posts into the brackets and test for proper fit.

6. Congratulations! You have successfully mounted your new brackets. Be sure to review the enclosed

catalog for other quality Warrior Products.

PARTS: 2- SHORT BRACKETS, WITH #1 MARKING

2- SHORT BRACKETS, NO MARKING

2- LONG BRACKETS
12- _” X 3/4” BOLTS WITH NUTS AND WASHERS

If you need further assistance installing your product, please contact us by email at

[e-mail] or call us at [phone].

THANK YOU FOR PURCHASING WARRIOR PRODUCTS