Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
sales@warriorproducts.com
WINDSHIELD LIGHT BRACKETS
INSTALLATION INSTRUCTIONS
WAR 1515 - ’76-’96 CJ & YJ WRANGLER
WAR 1510 - ’97 & UP TJ WRANGLER & LJ UNLIMITED
Congratulations on your purchase of Warrior Products Windshield Light Bracket for your
Jeep. Be sure to open the box and examine the contents before beginning. Read these
instructions completely before starting your installation. (NOTE: For CJ’s only. If you
have a factory windshield hinge mounted mirror on your Jeep, and you want to retain it, you
will want to purchase 8 – _”x _” NC bolts before strating and then follow the instructions
below. If you do not have a windshield mounted mirror go directly to step #4 and observe
step #6 when finished.)
1. The Warrior Light Bracket attaches to the front of your windshield, on the lower part of the
windshield hinge. Place the enclosed pattern on your factory windshield hinge to ensure
hole locations are the same. (Not all Jeeps are the same)
2. Place the enclosed pattern on the Warrior Light Bracket, mark hole locations and drill using
a 3/8” bit. Remember to use safety glasses when drilling.
3. You will want to apply some paint to the inside surface of the holes just drilled to prevent
rusting. Spraying paint onto a cotton swab and using it as a small paintbrush works well for
this.
4. Remove large bolts on windshield hinge and mount Warrior Light Bracket using two
stainless steel bolts provided for each side. Remove one bolt at a time, CAREFULLY, to
avoid dropping backing nuts located inside the framework.
5. Remount your mirror through the holes you drilled on the Light Bracket.
When finished, be sure to go back and check tightness of all bolts.
If you need further assistance installing your product, please contact us by email at
techsupport@warriorproducts.com or call us at (888) 220-6861.
THANK YOU FOR PURCHASING WARRIOR PRODUCTS