Warrior 1506 User Manual

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior Products, Inc.

16850 SW Upper Boones Ferry Rd

Ste. A

Durham, OR 97224

Phone [phone]

Fax [phone]

[e-mail]

MIRROR MOUNT HOLE PLUG KIT

INSTALLATION INSTRUCTIONS

WAR 1506

Kit BOM:

Qty 2 - Round Filler Plates
Qty 4 - Rubber Well Nuts
Qty 4 - Plastic End Caps
Qty 4 - _” x 3_” NC Button Cap Screws

1. We first recommend splitting the mirror from the door mount. If you’re separating them to

relocate the mirror, it is much easier to split them while they are still attached to the door. To do
this, remove the Torx head bolt from the underside of the mirror. With that bolt removed twist
the mirror to its folded closed position while gently lifting up. If it will not slide free with light
pressure DO NOT pull any harder as it will break the mirrors plastic surround. If this method is
not successful, reinstall the bolt so that the bolt head sticks down slightly, and use a mallet to tap
up on the mirror to push it out of the mount.

2. Next, from the inside of the door, remove the two Torx bolts holding the mirror mount to the

door. Slide mount out of the door and set aside.

3. Locate the rubber well nuts in your kit. Insert one well nut into each hole. Note that these will

be slightly difficult to get into place. Inserting the button cap screws supplied with the kit and
pushing or pulling the well nuts in will help you get them in place. You only need to get them in
far enough for the bolts to start threading.

4. With the well nuts in place, hold your plug plate in place and run the supplied button cap screws

into the holes and begin threading them in. Tighten bolts. You will notice that this will also pull
the well nuts firmly into place.

5. Finish the installation by putting the plastic hole plugs into the open end of the well nut inside.

These are intentionally left full length, for you to trim to fit. Trim in steps, removing only as
much as you have to. If in the event that these do not stay in place, we suggest using a little bit
of super glue to hold it into place.

6. Repeat Steps 1 through 5 for the other side of the vehicle.

If you need further assistance installing your product, please contact us by email at

[e-mail] or call us at [phone].

THANK YOU FOR PURCHASING WARRIOR PRODUCTS