Warrior 1480 User Manual

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior Products, Inc.

16850 SW Upper Boones Ferry Rd

Ste. A

Durham, OR 97224

Phone [phone]

Fax [phone]

[e-mail]

REAR LIGHT SPACER BRACKETS

INSTALLATION INSTRUCTIONS

WAR 1480 - ’07 & UP JK & UNLIMITED

Read these instructions completely before starting your installation.

1. Remove Spare Tire.

2. Unplug wire for tail light – you need to open tailgate and remove plastic vent on driver’s side.

3. Unbolt and remove Spare Tire Carrier.

4. Measure 3” up from the base for the light bracket and mark a line – Cut the Light Bracket on the

line using hacksaw or die grinder. (It will cut easy because it is alloy)

5. Take new bracket and lay it on top of the old bracket and mark the hole approximately _” from
the edge of both pieces and drill holes.

6. Cut wires and splice in 5inches of wire on each.

7. Remount Spare Tire Carrier, plug wire back in, pop vent cover back in place and mount Spare Tire.

If you need further assistance installing your product, please contact us by email at

[e-mail] or call us at [phone].

THANK YOU FOR PURCHASING WARRIOR PRODUCTS