Warrior 1150-RJR User Manual

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior Products, Inc.

16850 SW Upper Boones Ferry Rd

Ste. A

Durham, OR 97224

Phone [phone]

Fax [phone]

[e-mail]

MAXI-BREEZER TOP

INSTALLATION INSTRUCTIONS

WAR 1150 / RJR CG544B

LJ Unlimited ’04-’06

NOTE: Installation of this top requires a windshield retaining channel, if you do not have one it can be
purchased at your local offroad shop- Bestop part #51238-01

TOOLS NEEDED: #30 Torx Driver

1. Use #30 Torx Driver to remove 2 Torx screws in each speaker pod – let them hang in place

2. Install windshield retaining channel if needed

3. Turn Maxi-Breezer Top upside down & install to channel, make sure space between top

fabric and windshield flange is equal on both sides

4. Flip Maxi-Breezer Top over (keeping pressure on top while flipping to keep it from coming

loose from channel)

5. Wrap long center strap around sport bar & fasten through footman loop on windshield frame

then tighten securely

6. Attach corner straps and cinch until you have proper tension

7. Attach and cinch remaining straps until you have a tight fit

8. Reattach speaker pods

9. Extend remaining portion of Maxi-Breezer Top over rear Roll Cage and secure rear straps

around shoulder strap mount on Roll Bar on each side until you have proper tension

10. Adjust 4 side straps (2 on each side) until you have a tight fit

Your Maxi-Breezer Top is now fully installed. Enjoy!

If you need further assistance installing your product, please contact us by email at

[e-mail] or call us at [phone].

THANK YOU FOR PURCHASING WARRIOR PRODUCTS