Warrior 1085 User Manual

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior Products, Inc.

16850 SW Upper Boones Ferry Rd

Ste. A

Durham, OR 97224

Phone [phone]

Fax [phone]

[e-mail]

RECEIVER HITCH

INSTALLATION INSTRUCTIONS

WAR 1085

1. Remove bottom bumper bolts; threaded upwards into bottom of frame.

2. Slide hitch up alongside frame rails, reinstall bumper bolts through hitch

into frame to hold hitch in place. DO NOT TIGHTEN.

3. With a _” box end wrench, feed supplied _” nut through hole in bottom

of frame to upper hole, (step #3, figure #1) thread bolt into nut.
DO NOT TIGHTEN.

4. Install nut and bolt (step #4, figure #1) into lower center hole.

DO NOT TIGHTEN.

5. Tighten the 2 bolts on each side of frame to 65 ft/lbs. Tighten bottom

bumper bolts to 65 ft/lbs.

6. Using a _” drill bit, drill through frame using hitch hole as a guide (step

#6, figure #1).

7. Install last bolts through drilled hole. Tighten to 65 ft/lbs.

8. After test drive re-torque all bolts.

Do not exceed Vehicle Manufacturers Recommended Towing Capacity!

*Load Capacity 2,500 – 5,500 lbs.

If you need further assistance installing your product, please contact us by email at

[e-mail] or call us at [phone].

THANK YOU FOR PURCHASING WARRIOR PRODUCTS