Warren Evans Chester Ottoman, Oxford Ottoman, Richmond Ottoman, Ludlow Ottoman, Stockport Ottoman Assembly Manual

ASSEMBLY GUIDE

New Upholstered and Wooden Space Saving Ottoman Bed Range

Chester Ottoman (Wooden)

Richmond Ottoman

Oxford Ottoman (Wooden)

Ludlow Ottoman

Stockport Ottoman Minster Ottoman Ripley Ottoman

PLEASE READ THE USER GUIDE BEFORE FOLLOWING THESE INSTRUCTIONS

Please make sure that all the surfaces that you lean any of our products on are clean and soft so
as not to mark or damage the bed.

Please ensure that you wash your hands or that your gloves are very clean even after and during
unwrapping the products, to not mark the finished product in any way. We wish you to have an
excellent clean Warren Evans bed!

When unwrapping these beds please keep all the wrapping intact should it be needed for

1.

returns. Make a space in your bedroom for where the bed will actually be positioned.

Start the assembly process by leaning the head end against the wall of choice.

Open the 3 largest boxes, one of which contains both the foot end and the head end of the

2.

bed (this box also contains screws, bolts and allen key inside).

Place the head end on its feet leaning against your wall of choice. Place the foot end on its
feet to one side. (Do not slide the headboard onto the head end until instructed to do so).

Head End

Bolts x 12

There are 12 bolts, 3 that go in each of the legs. Put each bolt in but only one full turn so

3.

that it’s loosely connected.

2

The metal ottoman lifting mechanism must go at the head end of the bed.

4.

Make sure the exterior of the side (A) overlaps the head end (B).

(A)

(B)

(C)

UP

Make sure that the sides of the bed are
facing up

(D)

Hook the bracket (C) over the bolts (D), one
side at a time, onto the headboard first.
Then hook the foot end to the other end of
the sides.

3