The Ultimate PC to TV Browsing Experience!
Quick and Simple Set-up!
GETTING STARTED
What’s in the package
1
AA BATTERIES
WIRELESS
CONTROLLER
The package includes: Wireless Motion Controller, USB Receiver, two AA Batteries, 6 FT. HDMI
Cable, and Warpia TV Browser download information.
Wiring of PC to TV
2
Connect the laptop to the TV using the included HDMI Cable.
USB
RECEIVER
6FT. HDMI
CABLE
Make sure your TV is ‘on’
and is set to display the
correct video input.
WARPIA
TV BROWSER
Wireless Controller Instructions
3
Setup
Install batteries into the Wireless Controller.
Plug the USB Receiver into your computer.
Wait for your computer to recognize the Wireless Controller.
There are no special drivers to install.
Remote Functions
On/Off
“Escape” Key
Quickly back out of
full screen videos
and presentations
Lock Cursor
Prevent the cursor
from moving while
handling the Wireless
Controller
Mute
Mouse Buttons &
Scroll wheel
Volume Up/Down
Special Tip
You don’t have to point at the screen
Freespace
hold the Wireless Controller in the
position that is the most comfortable for
you. Small wrist movements give you
better control over the cursor than using
your whole arm.
®
technology allows you to
Warpia TV Browser Download
4
Download the WarpiaTV Browser by going to the following website and following the
instructions for download: www.warpia.com/warpiaTV.
When running the WarpiaTV Browser, you will need to configure which screen you would like
to view it on if in Extend mode with the TV acting as a second monitor . Simply click on the
button on the bottom right side of the Browser, choose the ‘Settings’ tab, then choose the
‘Screen’ tab on the left hand side to move the Browser to the TV.
WarpiaTV.Wired.QSG.R4
SWP500
Loading...