Warner Manufacturing Bull Dog Power Products 11067, Bull Dog Power Products 11065, Bull Dog Power Products 11066 User Manual

#11067 TRIPOD WORKLIGHT STAND

DANGER:

EXPLOSIVE ENVIRONMENTS. THIS IS NOT A VAPOR PROOF LIGHT.

Warning:
should be followed to reduce the risk of fire or electric shock. Failure to
follow these instructions could result in personal injury, property damage,
or death.

BULLDOGPOWER.COM
WARNERTOOL.COM

THIS LIGHT IS NOT INTENDED FOR USE IN POTENTIALLY

When using outdoor portable lights, basic safety precautions

1

Operating Instructions

1. Plug the light into properly grounded circuit.

2. Turn the light on by pushing the rubber button switch located on top of the

fixture.

3. Always make sure the light is placed on a firm level surface.

Safety Instructions:

1. The user must read and understand all instructions and labels attached

before using.

2. Do not submerse. Under wet or damp conditions use GFCI protected

circuits only. Keep plugs and receptacles dry.

3. Keep light at least 16 feet away from pools, spas or standing water.

4. Do not use with extension cords near water or where water may

accumulate.

5. Use only outdoor rated extension cords that have the three-prong grounding

plug.

6. To prevent fire or explosions keep the fixture away from all flammable

materials.

7. Never look directly into the light to avoid eye injuries.

8. The aluminum housing conducts electricity. Use extreme caution to avoid

contact with electrical wiring.

9. Do not pull on power cord to move this product.

10. Inspect cords and connections for any wear or damage before each use.

11. Never use this product if the light is damaged or bare wires are exposed.

If you require additional information, contact: Bull Dog Customer Service
1-800-444-0606.

1-year Limited Warranty

2

Set Up the Tripod Stand:

Loosen locking knob and pull legs away from center pole
(out) until all three legs make contact with the floor.
Retighten the locking knob when legs are firmly in place.

Attach Portable Stand to Tripod Stand:

Pinch the red locking buttons inward. Align the holes on the underside of the light bar with
the two metal locking tabs on the tripod stand. Release the locking buttons to lock the light
bar in place.

WARNING: Make sure the portable light bar
is connected completely to the locking tabs
on the tripod stand. Lift the portable light
handle to confirm. Failure to complete

this step may cause injury or damage to
the lights.

Extending the Tripod Stand
from 3 Feet to 5 Feet:

Unlock the locking
collars by twisting
collar counterclock­wise. Lift the pole
above the collar and
twist the collar
clockwise until tight.

3