Warmup TC24 User Manual

Warranty

This product is warranted against defects in material and
workmanship under normal conditions of use for a period of 12
months from the date of purchase. During this period, Warmup
will repair or replace the product if it is defective in normal
operating conditions in terms of materials or workmanship with
a new product of equivalent quality at Warmup’s discretion. This
warranty is void on any unit that has been tampered with,
damaged by accident, improper operation or incorrect
installation.

The warranty does not cover costs of transportation, removal,

installation or damage caused by misuse or accident. Any
defective product should be sent with the original invoice to the
supplier.

Warmup New Zealand Ltd

Freephone 0800 WARMUP (927 687)
www.warmup.co.nz

Warmtech Pty Ltd

Freephone 1300 138 126
www.warmtech.com.au

Features

This Programmable Rotary Timer is an electromechanical timing
device which allows a load to be switched over a 24 hour period
(at 30 minute intervals).

The device has 3 settings :

ON The load is activated overriding the set program.

(constantly on).

OFF The load is de activated

TIMER The load is automatically switched to the set

programmed times (1/2 hr. intervals)

Method of Operation

• Set the clock so that the correct time of day is adjacent to
the horizontal arrowhead.

• If the timer has been wired to switch the load ON for the
selected time periods, those periods must be selected in
order to activate the load by moving the appropriate pins
arranged around the clock face to the outward position (each
pin represents 30 minutes)

• If the timer has been wired to switch the load OFF for the
selected time periods, those periods must be selected in
order to deactivate the load by moving the appropriate pins
arranged around the clock face to the inward position.

• Move the slide switch to the desired operation mode i.e. ON

(constantly on), OFF and TIMER (as per settings) as and when
required.

NOTE: DO NOT TURN THE SWITCHING DIAL IN AN ANTI
CLOCKWISE DIRECTION AS THIS WILL DAMAGE THE DEVICE.

Installation Instructions

Neutral

To heating

element

Phase

Before wiring ensure that:

• All electrical connections are required by law to be
performed by a registered electrician and comply with New
Zealand standard NZS 3000:2007.

• The supply is disconnected at the distribution board

• All connections are secure and tested prior to activation.

• You have studied and fully understood the connection

diagram.

Specifications

Electrical rating 230 – 240V, ac 50 Hz
Power Consumption 1VA
Environmental Protection IP3X protection
Time selection ½ hr to 24 hours
Load 10A resistive, 8AX inductive, 850W
incandescent and 100mA
minimum switching current
Warranty. 12 months

Brown

Blue

Red