Page 1
Warmup - Primer
(ACC Primer)
EN
Description:
A ready to use, bond enhancing and solvent-free single component primer for
the preparation of absorbent and non-absorbent oors and walls with or without
surface heating. Ideal for use before laying Warmup Peel and Stick systems, levelling
compounds and tile adhesives.Suitable for use as a deep penetrating primer on
absorbent surfaces.
Suitable Substrates: Concrete; Cement Screeds; Anhydrite Screeds; Magnesite Screeds;
Levelling Compounds; Timber; Metal; Tile Backer Boards; Terazzo oors; Natural Stone;
Ceramic Tiles; Vinyl; Epoxy Paints, Epoxy Moisture Barriers; Water-Resistant Adhesive
Residues; MSP’s; Abraded Mastic asphalt.
Not suitable for use on PUR pre-coatings, melamine faced boards. Contacting
substrates, adhesives and compounds must be free of migrating elements.
Substrate preparation: The substrate must be dry, frost-free, solid, weight-bearing and
dimensionally stable. It must be free from contaminants that may impede adhesion
such as dust, dirt, oil, grease, release agents, loose material or surface laitance. Heated
surfaces must be switched o and allowed to cool back to ambient conditions before
application. The substrate must comply with the applicable National Standards,
Directives and Codes of Practice relating to its intended use.
Application: Shake well before use. Wear appropriate PPE. Apply a single coat evenly
with a roller or brush, avoiding pooling. Once dry the surface will be slightly tacky to the
touch. After use, clean tools with soap and water before the primer dries.
Safety instructions: Instructions for the safe use of our products can be found on our
safety data sheet on
www.warmup.co.uk.
Product contains: 2-methyl-2H-isothiazol-3-one and 1,2-benzisothiazol-3(2H)-one. Can
cause allergic reactions.
Technical specications:
Typical Consumption: Porous Substrates ≈ 20m²/l (Diluted 1:1 with Water). Non-Porous ≈
14m²/l (Undiluted)
Application Temperature: 15°C to 25°C
Ideal Application Air Humidity: 40% to 60%
Drying time: 30 - 60 minutes, at 20°C and 65% Relative Humidity. Increased air
humidity and/or lower temperatures delay drying. Lower air humidity and/or higher
temperatures accelerate drying.
Shelf Life: 12 Months in original container when kept out of direct sunlight and at
temperatures between 10°C and 25°C, avoiding frost. Diluted product must be used on
the day of dilution or discarded.
Contact
Warmup plc
www.warmup.co.uk
uk@warmup.com
0345 345 2288
Warmup plc n 704 Tudor Estate n Abbey Road n London n NW10 7UW n UK
Warmup GmbH n Ottostraße 3 n 27793 Wildeshausen n DE
Warmup - IM - ACC-Primer - V1.1 2021-10-07_EN
Loading...