WarmlyYours TempZone Shower Mat User Manual

TempZone™ Shower Mat (Bench & Floor)

INSTALLATION INSTRUCTIONS

STEP 1

Once the mortar bed has set, dry t the TempZone™
Shower Mat to verify its dimensions and ensure it ts

the contours of the shower area.

Conduct insulation & resistance tests. Record
readings on the warranty card found inside the

TempZone™ Installation instructions.

Step 2

Attach the mat to the suboor using hot glue.
Prepare the latex-modied thinset. Using a at
trowel, spread a coat of thinset over the installed

mat.

For best results, we recommend a 1” maximum
distance between the heating cable and the top of

the tile. (see Figure 6)

Please ensure the slope of the mortar bed is

maintained to direct water toward the shower drain.

STEP 1

STEP 2

Allow the thinset mortar to set. Conduct resistance
tests and record readings on warranty cards.

Step 3

Using a hot glue gun, secure the cold lead to
the mortar bed and over the shower curb. In

order to minimize tension on the cold lead, use
an “S” formation to bring the cold lead over the

shower curb. Do not allow the tip of the hot glue

gun to touch the cold lead as it may damage the

TempZone™ Shower Mat.

Direct the supply lead to the thermostat box or
junction box.

Installation Support • No Nonsense™ Warranty • [phone] • www.WarmlyYours.com

STEP 3

TempZone™ Shower Mat (Bench & Floor)

STEP 4

STEP 5

1”

CROSS SECTION OF THE LAYERS

Drain

Figure 6

Installation Support • No Nonsense™ Warranty • [phone] • www.WarmlyYours.com

Tile
Membrane
TempZone™
Cerazorb (optional)
Pan or Pack