WarmFlow SFP1 Installation Instructions Manual

Addendum

Incorporating: In-Roof Installation Instructions

Solar Thermal Systems

European Solar Keymark Approved

Products covered by this addendum:

Solar SFP1

In-roof installation of flat panel collectors

LEAVE THIS ADDENDUM WITH THE END USER

Q12-031 rev 0

1 Oct ‘10

1 WARNING

1.1 Weather-tightness

Installation of the flashing kit supplied with in-roof mounting kits should only be

undertaken by trained, experienced roofing professionals.

It is the responsibility of the roofing professional to ensure the suitability of the flashing

supplied for the specific installation and roof type and to ensure the weather-tightness
of the installation.

A continuous vapour barrier MUST be installed beneath the collector array, extending

down to the guttering, to prevent moisture ingress to the building in the event of
leakage of the flashing.

No claim for consequential loss or damage arising as a result of a defect of the flashing

or its installation shall be accepted by the manufacturer.

2 INSTALLATION

2.1 General Requirements

Select a suitable position for the collector. Ensure the section of roof to which the collector is
being installed is capable of supporting its weight and any likely wind and snow loads.

The collector should face as close as practicably possible towards south and not be shaded
by surrounding buildings, trees or other sections of the building to which it is being installed.
The collector must be installed on a section of roof with a tilt of between 15° and 90° to the
horizontal. Table 1 shows the effect of the tilt and orientation of the collector on
performance.

Tilt of

collector

Orientation of collector

South

South

-

east

South-west

East / West

North

-

east

North-west

North

30°

Recommended 4.3% loss 15% loss 27% loss 32% loss

45°

1.8% loss 7.1% loss 20% loss 36% loss 40% loss

60°

7.8% loss 14% loss 28% loss 44% loss 53% loss

Data derived from SAP2009

Table 1: Loss of performance due to collector angle and orientation

In-roof kits are available for fitting the collector to both tiled and slate roofs:

• tiled in-roof installation (refer to Section 2.2)

• slate in-roof installation (refer to Section 2.3)

IMPORTANT

Fill, flush and leak test the system PRIOR to installing the flashing

around the collector.

2

2.2 Tiled Roof Installation

3