Warmfloor24 LDHR062-150KB-S, LDHR062-200KB-S Safety Instructions And Operation Manual
English
INFRARED PATIO HEATER
Safety Instructions and Operation Manual
Model
LDHR062-150KB-S
LDHR062-200KB-S
1. This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning use of the appliance in a safe
way and understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
2. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
3. Warning: In order to avoid overheating, do not cover the heater.
4. Children of less than 3 years should be kept away unless continuously supervised
5. Children of less than 3 years and less than 8 years shall only switch on/off the appliance
provided that it has been placed or installed in its intended normal operating position and
they have been given supervision or instruction concerning use of the appliance in a safe
way and understand the hazards involved. Children aged from 3 years and less than 8
years shall not plug in, regulate and clean the appliance or perform user maintenance.
6. CAUTION- Some parts of this product can become very hot and cause burns.
7. Particular attention has to be given where children and vulnerable people are present.
8. WARNING: This heater is not equipped with a device to control the room temperature. Do
not use this heater in small rooms when they are occupied by persons not capable of
leaving the room on their own, unless constant supervision is provided.
9. The heater must be installed at least 1.8m above the floor.
10. The installation of the heater should not be close to curtains and other combustible
materials.
Brief Introduction
This product is infrared radiant heater with remote control and IP 65 approved. It is almost unlimited
used in outdoor, such as open bars, courtyard, plaza, station in winter etc. This patio heater is energyefficient, convenient, environmentally friendly and for better life etc.
And add the Bluetooth speakers and LED Lighting. Connecting your mobile phone or PC then can play
the music and control LED lighting.
Important Safety Instructions
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire,
electric shock, and injury to persons, including the following:
Read all instructions before using this heater
This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use
handles when moving this heater. Keep combustible materials, such as furniture, pillows, bedding,
papers, clothes, and curtains at least 3 feet (0,9 m) from the front of the heater and keep them away
from the sides and rear.
• Extreme caution is necessary when any heater is used by or near children or invalids and
whenever the heater is left operating and unattended.
• Do not operate any heater with a damaged cord or plug after the heater malfunctions, has been
dropped or damaged in any manner. Discard heater or return to authorized service facility for
examination and/or repair.
• This heater is not intended for use in bathrooms, laundry areas and similar indoor locations.
Never locate heater where it may fall into a bathtub or other water container.
• Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar
coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area
and where it will not be tripped over.
• To disconnect heater, turn controls to off, then remove plug from outlet.
• Connect to properly grounded outlets only.
• Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may
cause an electric shock or fire or damage the heater.
• To prevent a possible fire, do not block air intakes or exhaust in any manner (such as
newspaper, table-cloths, curtains, etc.) Do not use on soft surfaces, like a bed, where openings
may become blocked.
• No naked flame sources, such as lighted candles, should be placed on the apparatus.
• A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint,
or flammable liquids are used or stored.
• Use this heater only as described in this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock, or injury to persons.
• Always plug heaters directly into a MAINS socket outlet with a protective earthing connection.
Never use with an extension cord or relocatable power tap (outlet/power strip)
• Check if the voltage indicated on the nameplate of the appliance corresponds to the local mains
voltage before you connect the appliance.
• The appliance is not located immediately below a wall socket-outlet.
• The casting and the front cover of the appliance become extremely hot during operation. Pay
attention that, no combustible material due to wind or other environmental influences covers or
obstructs the appliance, such as curtains, marquees, flags, plastic foil etc.
• Do not touch the appliance. Caution! Risk of scald injury!
• In case of improper use, there is a risk of electrical shock and/or fire hazard. Operation of the
appliance must be discontinued and remove the mains plug immediately. Do not try to repair
the appliance by yourself. Please contact with the service agent or a suitably qualified electrician
for maintenance.
• Remove the plug from the power outlet and wait until the appliance is sufficiently cooled off
before cleaning.
• The appliance must only be mounted by an authorized specialist, paying attention to the
relevant regulations of the power supply companies and the regional construction regulations.
Save these Instructions
Specifications
Specifications
LDHR062-150KB-S
LADHR062-200KB-S
Voltage (V)
220-240V
Power (W)
1500W for LDHR062-150KB-S
2000W for LDHR062-200KB-S
IP protection
IP65
Infrared receiving Angle
60° ± 5°
Bluetooth receiver distance
≤20M
The speaker power
3Wx2
Bluetooth operation
A free Bluetooth App is available to download for this heater for either your Iphone, Ipad or android
device.
The “Sunkare heater” App will allow you to connect remotely to many heaters and Control speaker
and lamp independently.
To download, search for “Sunkare” in your App store and add to your device.
Bluetooth speakers connecting steps
1. In standby position, short press the remote-control button (pic), turn on the power of of the
Bluetooth speakers, then long press this button in order to enter into Bluetooth pairing mode.
2. Open the Bluetooth function in your iPhone, iPad or Android device, find the “Liangdi Heater” in
the device lists, then connecting.
3. Connecting successfully will have prompt tone, then you can play music by your iPhone, iPad or
Android device.
4. Button (pic) again, it will turn off the Bluetooth speaker, the next time open the speaker will
automatically connect your devices have paired.
RESET OPERATION
Press the Reset button shortly, the power will be adjusted accordingly (Low, Middle, High, ON/OFF)
Press the Rest button for at least 4 seconds, the heater will restore factory settings.
Remote Control Instructions
Button
Feature
1- Up Arrow
Up one heating level
2- Turn on/off the speaker
Short press, turn on/off the speaker
Long press, enter into Bluetooth pairing mode.
3- Down Arrow
Down one heating level
4- LED light on
Turn on the light
5- LED light off
Turn off the LED light
6- On
To switch the heater on:
Press ON. The patio heater has a soft start
function of 33% power. 4 seconds after the
heater has been turned on, it will automatically
switch to the last heating level used. In case of
the first-time use, after 4 seconds the heater
will automatically switch to 100% power.
7- Off
To switch the heater off:
Press off. The heater will switch to standby
mode (the receiver indicator will light up).
Notice
Use 2 pieces AAA size 1.5 V batteries in the remote control.
Remove the battery when not use for long time, thus the
lifespan of the battery when not use for long time, thus the
lifespan of remote control can be extended.
Choose the same specification battery when replacing the
battery inside, otherwise it may cause remote control not work,
thereby affect the normal use of the heater.
Please contract service agent for further help if you need the
function.
The remote-control function may be out of work if there is a
barrier between the remote control and heater.
Replacing the batteries duly so as not to affect the normal use
of heater and remote control.
Operation Instruction
• Remove all package material (including anti-vibration object of the lamp) and check the
appliance, supply cord and the plug for signs of damage.
• Pay attention to the mounting place and all mounting material (dowels, screws). Ensure
they are suitable and stable enough for mounting and lastingly holding of the appliance.
• Before mounting, the minimum safe mounting distances and tilt angles shown in the figures
must be strictly followed.
• The distance between the bottom edge of the appliance and the floor must be at least 1.8
M. See figure 2.
• There must be a distance of at least 0.25 M between the appliance and the ceilings, roofs or
other covers. See figure 2.
• There must be a distance of at least 0.5 Mat each side between the appliance and walls or
the like. See figure 2.
• Recommended degree to mounting surface is 45°.See figure 3.
• Pay attention that, the installation of the appliance must not add excessive wind load.
• Fix the mounting bracket to the ceiling first. Ensure that the place to be installed is secure
and firm. Then fix the appliance to the bracket.
• Adjust the desired angle of radiation and fest screw all screws. Check regularly the screw´s
connection. Mechanical bearing pressure and oscillation due to wind or rain could lead to
loosen.
• Plug in the power source and operate the remote control. Then observe, whether during the
first 10-15 minutes the appliance works trouble-free.
• If you do not use, please remote battery socket.
Figure 1: Mounting bracket and anchor dowels
provided Connection from the wall to the
infrared heater
Figure 2: Min. distance to floor, ceiling and
wall
Figure 3: Tilt Angle
Figure 4: Max. remote
Remote Control
Heater
6m Max
Cleaning and maintenance.
• This appliance is consisting of a robust and maintenance-free aluminum casing No user
serviceable parts inside.
• Remove the plug from the power outlet before cleaning and wait until the appliance is
sufficiently cooled off
• Wipe the appliance only clean and lint-free cloth or a soft brush.
• Never use abrasive cleaners, scrubbing brushes and chemical cleaners for cleaning!
• Can use alcohol to clean the appliance.
• To protect against electrical shock and danger of life, do not immerse cord, plug, or any part of
the appliance in water or other liquid.
• For heating element replacement, please contact the manufacturer or its service for heating
element replacement, please contact the manufacturer or its service agent or similarly qualified
person.
• Any other servicing should be performed by qualified service personnel.
Storage
Do not cord when heater storage, or heater is not use.
Disposal
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of the material resources.
To return your used device, please use the return and collection systems or
contact the retailer where the product was purchased. They can take this
product for environmental safe recycling.
Customer Service
• Repairs must be carried out by authorized specialists, thus ensuring electrical safety.
• Please contact with the service agent or suitably qualified electrician.
• Improper repairs could damage of failure which results from alteration, accident, misuse,
abuse, neglect, commercial use or improper maintenance.
• In line with our policy of continuous product development we reserve the right to change
the product and documentation specifications without notice.
Loading...