Waring WSB33X User Manual [en, es, fr]

Operation Manual

Manual de instrucciones

Manuel d’utilisation

Quik Stik

immerSion Blender

licuadora de mano WSB33X

Quik Stik® mixer plongeant

For your safety and continued enjoyment of this product, always read

Para su seguridad y para disfrutar plenamente de este producto, siempre lea

Afin que votre appareil vous procure en toute sécurité beaucoup de satisfaction,

the instruction book carefully before using.

las instrucciones cuidadosamente antes de usarlo.

lire attentivement le mode d’emploi avant de l’utiliser.

IMPORTANT SAFEGUARDS

When using an electrical appliance, basic safety precautions should always be followed, including the following:

READ ALL INSTRUCTIONS.

1. Unplug from outlet when not in use and before cleaning.

2. To protect against risk of electrical shock, do not put motor base, cord or plug in water or other liquid. Only the blade guard and shaft of this appliance have been designed for submersion into water or other liquids. Never submerge any other portion of this unit in any liquid.

3. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

4. Keep hands, hair, clothing, and utensils away from blade and mixing container while operating the Waring® Quik Stik® Immersion Blender to prevent the possibility of severe injury to persons and/or damage to the Immersion Blender. A spatula may be used but must be used only when the unit is not operating. Avoid contact with moving parts.

5. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or is dropped or damaged in any manner. Return the appliance to the nearest Waring authorized service facility for examination, repair, electrical or mechanical adjustment.

6. The use of accessory attachments not recommended or sold by Waring for this specific model may result in fire, electric shock or personal injury.

7. Do not use outdoors.

8. Do not let any cord hang over the edge of the table or counter. Do not let cord come into contact hot surfaces, including stovetop.

9. Do not place on or near a hot gas or electric burner, or in a heated oven.

10. Blade is SHARP. Handle carefully.

11. When mixing liquids, especially hot liquids, use a tall container or make only small quantities at a time to reduce spillage and possibility of injury.

SAVE THESE

INSTRUCTIONS

GROUNDING INSTRUCTIONS

This appliance must be grounded while in use to protect the operator from electrical shock. The appliance is equipped with a 3-conductor cord and 3-prong grounding-type plug to fit the proper grounding-type receptacle. The appliance has a plug that looks like the plug in drawing (1). An adapter, as in drawing (2), should be used for connecting the appliance plug to two-prong receptacles. The grounding tab which extends from the adapter must be connected to a permanent ground such as a properly grounded outlet box as shown in drawing (3) using a metal screw.

THE PARTS

2-Speed Control

Motor Base (Handle)

Cord Wrap

Protective Blade Guard

Stainless Steel Shaft

Metal Blade (not shown)

BEFORE YOU BEGIN

NOTE: Always unplug the Waring® Quik Stik® Immersion Blender before cleaning the metal blade.

Before using the Quik Stik®, a clean, damp cloth to remove any dirt or dust. Place the metal blade end of the hand blender under running water to rinse it. Dry thoroughly with a soft absorbent cloth. Read all instructions completely for detailed operating procedures.

USING YOUR

Waring

suggests that you wipe the unit with

WARING® QUIK STIK®

IMMERSION BLENDER

NOTE: Always unplug the Immersion Blender

• To prevent splattering, be careful never to remove the

Stik

Immersion Blender from the liquid while in operation.

• Blend ingredients to make salad dressing, whip eggs, whip cream, and to purée soups and sauces.

• Use HI Speed for liquid ingredients, and hold the protective blade guard at the bottom of the mixing container to prevent splattering.

• For recipes calling for ice, use crushed ice (not whole cubes) for best results.

NOTE: If a piece of food becomes lodged in the protective guard surrounding the metal blade, follow the safety instructions noted below:

1. Release the power button and unplug the unit from the electrical outlet.

2. Once the power source has been disconnected, use a spatula to carefully

remove the food lodged in the blade guard. Avoid injury. The blade is sharp. DO NOT USE YOUR FINGERS TO REMOVE LODGED

OBJECTS.

3. After the lodged food has been removed, plug the unit back into its power

supply and continue processing.

out of reach of children.

Quik Stik® after each use. Keep the

Waring®

Quik

CLEANING INSTRUCTIONS

THE QUIK STIK® IMMERSION BLENDER MUST BE CLEANED AND DRIED ACCORDING TO THE FOLLOWING INSTRUCTIONS AFTER EACH USE.

For Food Service Applications

• Wash, rinse, and sanitize the stainless steel portion of the Quik Stik to initial use, after each use, or whenever it will not be used again within a period of 1 hour.

• Clean and sanitize the plastic motor housing prior to initial use and after each use.

• Washing solutions based on non-sudsing detergents, and chlorine-based sanitizing solutions having a minimum chloride concentration of 100 PPM are recommended.

The following washing, rinsing, and sanitizing solutions, or their equivalents, may be used.

prior

SOLUTION PRODUCT

Washing Diversey

DILUTION IN WATER TEMPERATURE

4 Tbsp./Gallon Hot 115°F (46°C) Wyandotte Diversol BX/A Or CX/A

Rinsing Plain Water Warm 95°F (35°C) Sanitizing Clorox

Institutional

1 Tbsp./Gallon Cold 50–70°F

(10–21°C)

Bleach

• In repetitive use applications, frequent cleaning will prolong life.

To wash and sanitize the Quik Stik

1. Rinse the exterior and interior stainless steel portion of the Quik Stik

under running water. Scrub and flush the exterior and interior stainless steel portion to dislodge and remove as much food residue as possible.

2. Wipe down the exterior of the plastic housing and the stainless steel portion of the Quik Stik® with a soft cloth or sponge dampened with the washing solution.

3. Immerse approximately 3/4 of the length of the stainless steel portion in a container of the washing solution and run for two (2) minutes on High.

4. Repeat steps two (2) and three (3) using clean rinse water in place of the washing solution.

+ 14 hidden pages