Waring WPO500 Instruction Manual
SINGLE DECK PIZZA OVEN
HORNO PARA PIZZA DE UN NIVEL
FOUR À PIZZA À UN NIVEAU
WPO500
For your safety and continued enjoyment of this product,
always read the instruction book carefully before using.
Para su seguridad y para disfrutar plenamente de este producto,
siempre lea las instrucciones cuidadosamente antes de usarlo.
An que votre appareil vous procure en toute sécurité beaucoup de satisfaction,
lire attentivement le mode d’emploi avant de l’utiliser.
IMPORTANT SAFEGUARDS
READ ALL INSTRUCTIONS
When using electrical appliances, basic safety precautions should
always be followed including those listed below:
1. To protect against electrical hazards, do not immerse oven in
water or other liquids.
2. NEVER clean with water jets, which can result in critical bodily
injury or death.
3. DO NOT USE if cord or plug is damaged or if machine has
malfunctioned, been dropped or damaged. Return appliance to
the nearest authorized service facility for examination, repair or
electrical or mechanical adjustment.
4. Do not use outdoors.
5. Do not let cord hang over edge of table or counter, or touch
hot surfaces.
6. Improper installation or use can result in electrical shock, injury,
or damage to your oven or property.
7. Your pizza oven is a heavy-duty appliance designed for
commercial use, and intended to be operated by trained
professionals only.
8. To prevent risk of re, oven should be installed in a
noncombustible environment. Any combustible materials must
be at least 18 inches away from sides, front and back of oven
and at least 40 inches from top.
9. Oven must be thoroughly cleaned before rst use and after all
uses (see USE AND CARE).
10. Always be sure to disconnect oven from power source when not
in use and before cleaning or servicing.
11. Always allow oven to cool before moving or servicing. Surfaces
are hot during use and remain hot for a while, even after power
is off.
12. Do not allow insertion of any foreign object into any ventilation
or exhaust opening; this can cause electric shock, re or
damage to the oven.
13. Never block air intakes or exhaust openings, or use on
cushioned surfaces where blockage may occur.
2
14. This appliance is not intended for use by persons (including
children) with reduced physical sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
15. Extreme caution should be exercised when using containers
constructed of the following materials in the oven: paper,
cardboard, plastic or similar products.
SAVE THESE INSTRUCTIONS
APPROVED FOR
COMMERCIAL USE
CONTENTS
Important Safeguards .................................................................. 2
Grounding Instructions ................................................................. 4
Introduction .................................................................................. 5
Parts and Accessories ................................................................. 6
Oven Installation ........................................................................... 8
Pizza Ceramic Deck Installation & Conditioning .......................... 8
Before Using Your Oven ............................................................... 9
Baking Instructions ....................................................................... 9
Tips and Hints ............................................................................ 10
Use and Care ..............................................................................11
Installing and Replacing Oven Light ........................................... 12
Safety Features .......................................................................... 13
Warranty ..................................................................................... 14
3
120V GROUNDING INSTRUCTIONS
For your protection, this appliance is equipped with a 3-conductor
cordset.
120 volt units are supplied with a molded 3-prong grounding-type
plug (NEMA 5-15P) and should be used in combination with a
properly connected grounding type outlet as shown in Figure 1.
If a grounding type outlet is not available, an adapter, shown in
Figure 2, may be utilized to enable a 2-slot wall outlet to be used
with a 3-prong plug (except in Canada and Europe).
Referring to Figure 3, the adapter must be grounded by attaching
its grounding lug under the screw of the outlet cover plate.
Caution: Before using an adapter, it must be determined that the
outlet cover plate screw is properly grounded. If in doubt, consult
a licensed electrician. Never use an adapter unless you are sure
it is properly grounded.
Note: Use of an adapter is not permitted in Canada and Europe.
EXTENSION CORDS
Use only 3-wire extension cords that have 3-prong grounding-type
plugs and 3-pole cord connectors that accept the plug from the
appliance. Use only extension cords that are intended for indoor
use. Use only extension cords having an electrical rating not less
than the rating of the appliance. Do not use damaged extension
cords. Examine extension cord before using and replace if damaged.
Do not abuse extension cord and do not yank on any cord to
disconnect. Keep cord away from heat and sharp edges.
NOTE: This appliance is for 120 volts only and should not be used
with a converter.
4
INTRODUCTION
The Waring® Commercial Pizza Oven with 18" x 18" ceramic deck
can accommodate large pies, maintaining consistent temperatures
to ensure that pizza cooks from the bottom as well as the top.
A major benet of a pizza stone over a pizza pan is the way that
the ceramic stone drives moisture away from the crust, resulting
in extra crispness.
Adjustable temperature control from 150°F to over 800°F allows you
to cook a wider variety of items, and bakes pizza fast whether using
fresh, frozen or par-baked dough. Pizza oven controls are designed
for simplicity, with quick-touch switches and indicator lights for
Power, Interior Oven Light, and Top and Bottom Elements. Superior
heat technology ensures quick heat-up and recovery, for consistent
oven temperatures that guarantee great results.
5
PARTS AND ACCESSORIES
8
1
2
3
10
9
1. Temperature Gauge
2. Temperature Control Knob
3. Manual Timer (minutes)
4. Main Power On/Off Switch
5. Oven Light On/Off Switch
6. Top Element On/Off Switch
7. Bottom Element On/Off Switch
8. Ceramic Pizza Deck (packed separately)
9. Door Handle
10. Tempered- Glass Door
11. Interior Light (not shown)
12. Top Heating Element (not shown)
13. Bottom Heating Element (not shown)
14. Rear Exhaust Vent (not shown)
15. Deck Cleaning Brush
16. Adjustable Legs (packed separately)
17. Power Cord (not shown)
4
5
16
7
6
15
6
1. Temperature Gauge
Lets you visually monitor oven temperature.
2. Temperature Control Knob
Simple dial knob to select temperature settings.
3. Manual Timer
Timer range is 30 minutes. An audible signal (single chime) indicates
selected time has elapsed. NOTE: TIMER DOES
NOT TURN OVEN ON OR OFF.
4. Power On/Off Switch with Indicator Light
Main power control for oven.
5. Oven Light On/Off Switch with Indicator Light
Turns interior light on/off.
6. Top Element On/Off Switch with Indicator Light
Turn off for items that do not require full direct top heat.
7. Bottom Element On/Off Switch with Indicator Light
Turn off for items that do not require full direct bottom heat.
8. Ceramic Pizza Deck
18" x 18" Pizza Deck ts into base of oven’s interior – maintains
temperature very well and ensures that pizza cooks from the bottom
as well as the top – pizza or bread can be placed directly on deck.
9. Door Handle
Heavy-duty, easy-to-grip design.
10. Tempered Glass Door
Lets you monitor the cooking process.
11. Interior Light
Replaceable bulb, removable heatproof glass bulb cover.
12. Top Heating Element (not shown)
Ideal for top browning; turn off when top heat is not required.
13. Bottom Heating Element (not shown)
Sits directly below pizza deck; turn off when bottom heat
is not required.
14. Rear Exhaust Vent (not shown)
Directs any exhaust from cooking process to the side of unit and away
from walls.
15. Deck Cleaning Brush
Features heavy-duty bristles and a scraper for cleaning the deck
without damaging the ceramic.
16. Adjustable Legs
Four legs must be attached to oven before using (see Before Using
Your Oven below).
17. Power Cord
7
OVEN INSTALLATION
• After removing the outer shipping carton and packaging
material, place the oven on the floor or other flat surface.
• Open oven and remove any instructions or packaging material
shipped in the unit.
• With sufcient help, lift up the front of the oven and attach the
two front legs (packed separately in styrofoam), carefully twisting
each one into a corner and hand-tightening. Lift the back of the
oven approximately 5 inches and block into position using a piece
of wood or other solid object. Then, attach the two back legs and
hand tighten.
• Move the oven to its nal location. Adjust the bottom portion
of the legs to level the unit. (g. 1)
PIZZA CERAMIC DECK
INSTALLATION & CONDITIONING
Read these instructions carefully before installing or
conditioning the ceramic deck. New deck must be conditioned
(pre-dried) prior to first use.
• Handling the Ceramic Deck: If deck is struck against hard
surface before, during or after installation, it can develop a full
or hairline crack which may expand over time and require you to
replace it.
• Installing the Deck: Open the oven door and place ceramic pizza
deck into the bottom with the slots on front of deck facing front
of oven. Be sure the deck is rmly set in place. Do not force or
wedge it. (g. 2)
• Conditioning the Deck: Pre-dry ceramic deck by carefully
following instructions in the following section, BEFORE USING
YOUR PIZZA OVEN. NOTE: Failure to follow conditioning
instructions will cause deck to crack or warp and will void
warranty.
8
SLOTS
(fig. 1)
(fig. 2)
BEFORE USING YOUR PIZZA OVEN
• Place oven in a well ventilated area to burn off any residual dust
from manufacturing.
• Plug unit in, open door and set Temperature Control to 400˚F
(205˚C). After one hour, close door and increase temperature
to 500˚F (260˚C) for at least 1½ hours.
Note: The oven may emit an odor during this process; this is
normal and not harmful, and should quickly dissipate.
• Turn off the oven and allow it to cool completely. Remove any
smoke residue from the interior with a dry cloth.
• Place clean, cool oven in the area where it will be used. Be sure
there is at least 6 inches’ clearance between sides and top of oven
and any wall or cabinet.
• Check to ensure nothing is blocking the exhaust vent on back
of unit.
BAKING INSTRUCTIONS
NOTE: Only pizza and breads can be placed directly on the pizza
deck. All other food items must be put onto a tray or into a container
rated for high temperature use.
Set the Temperature Control Knob to the desired temperature to
preheat oven. Watch the Temperature Gauge; when it reaches the
temperature selected, the oven is ready to use.
The Pizza Oven can be used to bake both fresh and frozen products.
Frozen items should go right from the freezer into the heated oven.
Cooking time will vary depending on the consistency and weight of
the product.
9
The temperature range for baking fresh pizza is usually between
500˚F (260˚C) and 575˚F (300˚C), depending on the individual product.
Generally, frozen items are cooked at a lower temperature, but
always follow recommended cooking instructions.
Bake pizza until the cheese bubbles and the bottom is evenly
browned, rotating it during the baking process if necessary.
Open and close door quickly when putting pizza in oven to prevent
heat from escaping, which can slow down cooking time.
TIPS AND HINTS
• Be sure ceramic pizza deck is dry. Wet spots or spills will cause
food to stick.
• Never season the ceramic pizza deck with any type of baking oil.
• Increase temperature during heavy production times to maintain
ideal baking temperature. Be sure to decrease it when rush slows
to prevent burning.
• If toppings need more time to cook, a piece of screen placed
under pizza can prevent bottom from overcooking.
• Pizza with heavy toppings requires a lower temperature and longer
baking time.
• Scrape off burnt residue from pizza deck daily with deck brush
provided. Buildup can cause an “off” avor and increase bake
time.
• Frozen items cannot be placed directly on hot deck to thaw.
Place food onto a screen or into a pan.
10
USE AND CARE
Daily cleaning is suggested to keep oven performing at its best.
ALLOW OVEN TO COOL COMPLETELY BEFORE CLEANING.
1. Always unplug the oven from the power source.
2. Do not use any sharp or hard kitchen utensils on the oven as
this could damage the surface of the appliance.
3. To clean ceramic pizza deck, remove deck from cool oven.
With the provided deck brush, scrape off hardened spillage.
To clean heavily soiled decks, return deck to oven and run at
highest temperature in a well-ventilated area for ½ hour. When
oven and deck are cool, remove deck and brush off residue.
NOTE: Never use high-abrasion brushing or water to clean
deck, or immerse or let any water or any other liquids come
into contact with the ceramic deck. Any of these can cause
deck to crack.
4. Wipe interior of oven with damp cloth, avoiding heating
elements.
5. When cleaning stainless steel exterior, use stainless steel
cleaner and wipe in the direction of the grain.
6. To clean the glass door, use a glass cleaner or damp cloth and
dry with clean cloth.
7. When opening oven door, be sure to guide the door while
lowering it. Doing so will prevent possible damage to the door
jamb after an extended period of time.
8. For further information or to purchase additional accessories,
please phone Waring Customer Service at 1-800-492-7464.
If there is something wrong with this product, please contact
Ecolab Equipment Care (EEC/GCS) service call center at
1-800-822-2303 or email servicerequest@ecolab.com.
11
INSTALLING AND REPLACING OVEN LIGHT
(Bulb Type: G9 120V/25W Halogen – Can be purchased at local
retail/home improvement stores)
A. Be Sure Oven is Completely Cool and Unplugged
B. Remove the Glass
Bulb Cover
Locate bulb cover in back
right corner. Carefully twist
counterclockwise and remove.
C. Remove Bulb
Grasp bulb and gently pull
straight out to remove.
D. Replace Bulb
Without touching the bulb
with bare hands (as this will
reduce the lifespan), use a
clean tissue or cloth glove
to position new bulb
carefully and push in to
engage.
E. Re-attach Glass Bulb Cover
Twist bulb cover clockwise
to secure.
12
Loading...