Waring WPM60 Instruction Booklet

Popcorn Maker
WPM60
INSTRUCTION BOOKLET
For your safety and continued enjoyment of this product, always read the instruction book carefully before using.
IMPORTANT SAFEGUARDS
When using any electrical appliance, basic safety precautions should always be followed, including the following:
1. READ ALL INSTRUCTIONS BEFORE USING.
2. Do not touch hot surfaces. Always use handles or knobs.
3. To avoid any risk of electrical shock, do not immerse cord or plug into water or other liquid.
4. This appliance should not be used by or near children, or individuals with certain disabilities.
5. Unplug main power cord from outlet while not in use and before cleaning.
6. Allow HOT parts to cool down before maneuvering.
7. Do not operate the appliance with a damaged cord or plug, or after the appliance malfunctions or has been damaged in any matter. Send the unit to the nearest authorized service center for examination, repair or adjustment. (ONLY technicians should open up the unit).
8. The use of any accessories or attachments not recommended by the manufacturer may cause injury.
9. Do not pop kernels with a dry pot (without oil).
10. Do not immerse popping kettle in water.
11. Pot surface is HOT and should NOT be touched during popping or just after use.
12. Unplug, allow to cool, clean and cover the unit and store in a dry and safe place if not being used for a long time.
13. Do not let power cord hang over edge of table or counter or touch any hot surfaces.
14. Do not place the unit on or near a hot gas or electric burner or in a heated oven.
15. Extreme caution must be paid when moving the appliance containing hot oil or other hot liquids.
16. Turn ALL switches to OFF position before disconnecting power plug from the wall supply outlet.
17. Not recommended for outdoor use.
18. Do not use appliance for other than indicated usage.
19. To avoid overheating, always add oil and then kernels before operating.
20. Extreme caution must be paid when unloading popcorn. Always place the unit over a countertop so that residual hot oil or water running out will not cause burns.
21. KEEP OUT OF REACH OF CHILDREN.
22. DO NOT CLEAN USING ANY ABRASIVE MATERIAL.
23. NEVER FORCE ANY PARTS OR BRACKETS INTO POSITION.
24. NO PARTS ARE INTENDED FOR THE DISHWASHER.
SAVE THESE INSTRUCTIONS FOR COMMERCIAL USE ONLY
Model No. & Specifications:
Model No: WPM60 Voltage: AC 120V~60Hz Input Power: 1000W Please read this user manual carefully before assembling and using.
BEFORE FIRST USE
– With a damp cloth, wipe the kettle and internal surfaces of the popcorn maker.
– Dry thoroughly.
ASSEMBLING
NOTE: Make sure the popcorn maker is unplugged before you do the following:
– Install the kettle by the pivots on the supporters, which are built into the roof of the
unit.
– Connect the kettle plug to the socket located on the front right roof panel and twist to
lock into place.
– Attach doors to the door frames by inserting hinge pins into the hinges on each side of
the front of the unit.
OPERATING INSTRUCTIONS
NOTE: All foodservice equipment should be operated by trained personnel.
1. Your Waring Commercial Popcorn Maker has 3 function switches:
I. Warming Light
II. Kettle Stirrer
III. Stainless Steel Kettle Heater
2. Plug the popcorn maker power cord into the wall outlet.
3. Switch on the warming light and heater (I & III), and then pour in recommended
amount of oil. Recommended oil amount is ¼ - ¹⁄3 cup (0.6-0.8 litre).
4. Kettle should be pre-heated for 3 to 4 minutes with oil (until steam starts coming out
from the kettle).
5. Measure 1 cup of popcorn kernels, open the kettle lid and pour in kernels. Salt can
also be added to the mixture. Close the kettle lid.
Caution: Lid may be hot. Use oven mitts or potholders.
6. Switch ON the Stirrer (II) immediately to begin the popping process.
7. You can close the 2 front doors while popping (or leave them open to reduce cabinet
moisture).
8. Popcorn starts popping out through the lid after about 2 to 3 minutes.
9. When popping stops, open doors, hold the red insulated kettle handle and empty the
remaining popcorn from the kettle by turning counterclockwise.
NOTE: Additional batches of popcorn can be popped immediately.
10. Switch off the stirrer and heater (II & III) when popping is completed. The warming
light (I) can remain on to display and keep popcorn warm.
11. Serve your popcorn with popcorn scoop provided.
12. Remove plug from power supply when the unit is not in use.
13. Repeat step 5 to 9 to continue popping. NOTE: Oil does not have to be preheated if
popping continuously.
CAUTION: DO NOT LEAVE POPCORN POPPER UNATTENDED WHILE IN USE.
Loading...
+ 5 hidden pages