Waring ES1500 PRO Quick Start Manual

QUICK START GUIDE

ESPRESSO MAKER

ES1500

PARTS

V

C

F

G

A

H

B

Q

M

I

R

O

S

L

A. Main housing
B. On/Off switch
C. Control lever
D. Steam/water dispensing lever
E. Steam/water wand
F. On Indicator lamp
G. Boiler temperature control lamp
H. Steam function indicator lamp
I. Boiler temperature thermometer (˚C and ˚F)
J. Espresso spout (single or double)
K. Water tank
L. Ground espresso holder
M. Pod holder
N. Grille
O. Drip tray
P. Filter (not shown)
Q. Ta m p e r
R. Cup warmer
S. Crema enhancer
T. Power cord (not shown)
U. Coupling seat
V. Scoop

J

GETTING STARTED

D

K

E

U

N

1. Unpack the Vero Barista™ Espresso Maker:
DO NOT leave plastic packaging materials
around children.

2. Wash water tank (K) with warm soapy
water, rinse and dry. Fill water tank with
clean water to the MAX ll line, then secure
it rmly into position.

3. Be sure that the control lever (C) and steam/
water dispensing lever (D) are in the vertical
standby position, and then switch the ma­chine to the On position using the On/Off
switch (B). Espresso maker takes approxi­mately 5 minutes to heat up.

4. Making 1 espresso cup – Attach the single
espresso spout to the holder (J).

Making 2 espresso cups – Attach the

double espresso spout to the holder (J ).

5. If using ground espresso – use the scoop
(V) to measure the grounds to ll the ground
espresso holder (L) and use the tamper
(Q) to lightly press espresso grounds down.
Secure the holder to the front of the
machine. Note: 2 scoops (14 grams) max.

If using an espresso pod – place pod inside

the pod holder (M) and secure the holder to
the front of the machine.

6. Place one or two cups under the holder,
and activate the coffee function by pulling
the control lever (C) forward toward the
coffee cup symbol.

7. When the espresso has been dispensed to
the desired level, push the control lever (C)
back to the vertical standby position.

Making Cappuccino or Latte

If you wish to make cappuccino or latte,

push the control lever (C) back to activate

QUICK START GUIDE

the steam function. The steam function
indicator lamp (H) and boiler temperature
control lamp (G) will turn on. When the
boiler temperature control lamp turns
off again, the machine is at the right
temperature to make steam.

Put the steam/water wand (E) into a frothing

pitcher lled with milk and pull the steam/
water dispensing lever (D) forward. Milk will
begin to froth. CAUTION: DO NOT direct
the steam/water wand toward any parts of
the body.

Hot Water Function

Be sure that the Control lever (C) is in the

vertical standby position and that the
machine has been heated for at least 5
minutes. Place container underneath the
steam/water wand (E) and pull the
steam/water dispenser (D) forward. To stop
the ow of hot water, push the dispenser
back to the vertical standby position.

(CONTINUED)

Do not throw away these instructions. READ BEFORE OPERATING your new

TM

Waring Pro

Espresso Maker. Keep for further reference.

These helpful hints are intended to be a supplement to the Instruction Booklet. In
order to ensure safe operation and optimum performance, please read the entire
Instruction Booklet.

IMPORTANT!

©2012 Waring Consumer Products 12WR131331 PG-29864