Waring DMC Series Operation Manual

2-Speed Drink Mixers

Operation Manual DMC Series

For your safety and continued enjoyment of this product, always read the instruction book carefully before using.

3

HELPFUL HINTS

1. Always unplug the Waring®2-Speed Drink
Mixer before disassembling or assembling
parts.

2. Be sure to keep all the instructions, parts
lists, and service information in a safe and
handy place.

3. Only use crushed ice or small cubes in
the Waring

®

2-Speed Drink Mixer.

4. Clean the Waring

®

2-Speed Drink Mixer

thoroughly before initial use.

5. Keep containers clean. Wash, rinse and
sanitize thoroughly after use.

6. Be sure that all detachable parts are fastened
tightly before operating the Waring

®

2-Speed

Drink Mixer.

7. Only operate the Waring

®

2-Speed Drink Mixer

when it is fully assembled.

8. To avoid splashing drinks of thin consistency
operate on Low Speed.

WARRANTY

ONE YEAR LIMITED W

ARRANTY

Waring warrants every new WARING

®

COMMERCIAL PRODUCT to be free from
defects in material and workmanship for a
period of 1 year from the date of purchase when
used with foodstuffs, nonabrasive liquids (other
than detergents) and nonabrasive semi-liquids,
proving it has not been subjected to loads in
excess of the indicated rating.

Under this warranty, the Waring Commercial
Division will repair or replace any part which,
upon examination, appears to us to be
defective in materials or workmanship,
provided the unit is delivered prepaid to the
Waring Service Center at Torrington, CT 06790,
or any Authorized Service Center.

This warranty does not: a) apply to any unit
which has become worn, defective, damaged
or broken due to misuse, repairs, or servicing
by other than the Waring Service Center or
an Authorized Service Center or due to
abuse, misuse, overloading or tampering;
b) cover consequential damages of any kind.

This warranty gives you specific legal rights, and
you may have other rights which vary from state
to state so that certain limitations or exclusions
set forth above may not apply to you.

WARNING - This warranty is VOID if the

appliance is used on
Direct Current (D.C.)

Waring Commercial
314 Ella T. Grasso Ave.
Torrington, CT 06790

www.waringproducts.com

SERVICE

Refer to the list of Authorized Service Centers
enclosed with your Waring

®

Product
for the name of the nearest Service Center, or
contact Waring in one of the following 3 ways:

1) Mail:

SERVICE CENTER
314 Ella T. Grasso Ave.
Torrington, CT 06790

2) Product Service: [phone] or

(800) 4-WARING

3) Internet: http://www.waringproducts.com

E-mail: [e-mail]

Ship units for repair to the above address or to
an Authorized Service Center.

Do not ship to a Waring Sales Office.

013753 R

V12 0702

CLEANING & SANITIZING
INSTRUCTIONS

1. Rinse container thoroughly under running
water. Add 8 ounces of clean rinse water to
container. Place container in normal operating
position on mixer and run on high speed for
two (2) minutes. Empty container.

2. UNPLUG MIXER POWER CORD FROM
ELECTRICAL OUTLET

3. Loosen and remove thumbscrew (1) and
container support (2). See Illustration C.

4. If your mixer has a chrome-plated metal switch
actuator (Illustration D) loosen and remove
thumbscrew (3) and On/Off switch actuator (4).

If your mixer has a black plastic switch
actuator (Illustration E), snap-off and remove
switch actuator knob.

5. Carefully remove stainless steel panel.

6. Wash, rinse, and sanitize the thumbscrews,
container support, On/Off switch actuator,
stainless steel panel, and container. Sanitize
these parts by immersing in sanitizing solution
for two (2) minutes. Shake excess moisture
and allow parts to air dry.

7. Working from the top down, wash, rinse, and
sanitize the portion of the mixer housing
situated directly over the container and the
portion of the spindle above the agitator, using
absorbent wiping cloths moistened with
cleaning solution, rinse water and sanitizing
solution.

8. Reassemble panel, On/Off switch actuator,
container support and thumbscrews to mixer
housing.

9. Wash, rinse, and sanitize the agitator and
the bottom of the spindle (Illustration A and B)
as follows:

Plug the Waring

®

2-Speed Drink Mixer cord

into electrical outlet.

Add 8 ounces of washing solution to
container and place in normal operating
position on mixer.

Run on high speed for a minimum of two
(2) minutes.

Empty container and repeat two-minute run
with 8 ounces of water.

Empty container, and repeat two-minute
run with 8 ounces of sanitizing solution.

Empty container. Run motor for a few
seconds with empty container in normal
operating position to spin off any excess
moisture. Empty container. Do not rinse
container, spindle or agitator after sanitizing
is completed. Allow all parts to air dry.

Wash, rinse, and sanitize as outlined above prior
to initial use, and whenever mixer will not be
used again within a period of one hour to avoid
bacteria build up.

Surfaces of the mixer housing which are outside of
the food contact areas may be cleaned as required,
using wiping cloths moistened with cleaning
solution, rinse water and sanitizing solution.

UNPLUG POWER CORD FROM ELECTRICAL
OUTLET BEFORE CLEANING HOUSING.
Prevent liquid from running into housing by
wringing all excess moisture from wiping cloths
before using them.

Washing solutions based on non-sudsing
detergents, and chlorine-based sanitizing
solutions having a minimum chlorine
concentration of 100 PPM are recommended.

The following washing, rinsing, and sanitizing
solutions, or their equivalents, may be used:

2

1

IMPORTANT
SAFEGUARDS

READ ALL INSTRUCTIONS

1. To protect against electrical hazards, do not
put the Waring

®

2-Speed Drink Mixer in water

or other liquid.

2. Unplug from outlet when not in use, before put­ting on or taking off parts, and before
cleaning.

3. Avoid contacting moving parts.

4. Do not operate the Waring

®

2-Speed Drink
Mixer or any other electrical equipment with
a damaged cord or plug, or after the unit mal­functions, is dropped or damaged in any man­ner. Return it to the nearest authorized service
facility for examination, repair, or adjustment.

5. Do not use outdoors.

6. Do not let cord hang over edge of table or
counter, or touch hot surfaces.

7. Do not operate the mixer unless the U-shaped
stabilizing leg on the bottom of the unit is
unfolded and fully seated in position, projecting
from the rear of the base.

8. Put this list in a safe place. Do not discard.

SAVE THESE
INSTRUCTIONS

GROUNDING
INSTRUCTIONS

For your protection, the Waring®2-Speed Drink
Mixer is equipped with a 3-conductor cord set.

120-Volt units are supplied with a molded
3-prong grounding-type plug, and should be
used in combination with a properly connected
grounding-type outlet as shown in Figure A.

If a grounding type outlet is not available, and
adapter, shown in Figure B, may be obtained
to enable a 2-slot wall outlet to be used with
a 3-prong plug.

Referring to Figure C, the adapter must be
grounded by attaching its grounding lug under
the screw of the outlet cover plate.

CAUTION: Before using an adapter, it must be
determined that the outlet cover plate screw is
properly grounded. If in doubt, consult a licensed
electrician.

Never use an adapter unless you are sure it is
properly grounded.

NOTE: Use of an adapter is not permitted
in Canada

SAVE THESE
INSTRUCTIONS

HOW TO USE YOUR
WARING®2-SPEED
DRINK MIXER

Your new Waring®2-Speed Drink Mixer has an
automatic ON/OFF switch, which starts the motor
when the container is placed in the proper
position on container support.

The motor will continue to operate while the
container remains on the mixer.

Removal of the container will shut off the motor.

The 2-speed switch on top of the Waring

®

Drink Mixer regulates the operating speed.
Choose either High Speed or Low Speed.
For mixing heavy drinks, use High Speed only;
and for light drinks, use Low Speed.

For maximum stability, unfold stabilizing leg on
base of the unit. (DMC20 model only)

SOLUTION PRODUCT DILUTION IN WATER TEMPERATURE

Washing: Calgon®Cargolac 1 Tablespoon/Gallon Hot(115°F)
Rinsing:

Plain W

ater

Plain W

ater

W

arm ( 95

°F)

Sanitizing: Clorox

®

Institutional Tablespoon/Gallon Cold (50°F- 70°F)

Bleach