Waring 6001C Instruction Manual

JUICE EXTR ACTOR
6001C IB
For your safety and continued enjoyment of this product,
always read the instruction book carefully before using.
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be taken, including the following:
READ ALL INSTRUCTIONS.
2. Unplug from outlet when not in use, before putting on or taking off parts.
3. To protect against risk of electrical shock, do not put motor housing in water or other liquids.
4. This appliance is not suitable for use by children.
5. Avoid contact with moving parts.
6. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or has been dropped or damaged in any manner. Return appliance to the nearest authorized service facility for examination, repair or mechanical adjustment.
7. The use of any attachments not recommended or sold by the manufacturer is not permitted. No other cover or collector bowl should be used. Should this happen, accidents could occur. All warranty claims would be void in this case.
8. Do not let cord hang over edge of table or counter, or touch hot surfaces.
9. Always make sure juicer lid is secure beneath springs before motor is turned on. Do not loosen lid while juice extractor is in operation.
10. Be sure to turn switch to OFF position after each use of your juice extractor. Make sure the motor stops completely before disassembling.
11. Do not put your ngers or other objects into the juice extractor opening while it is in operation. If food becomes lodged in the opening, use food pusher or another piece of fruit or vegetable to push it down.
12. Please keep these operating instructions in a suitable and safe place.
SAVE THESE INSTRUCTIONS
APPROVED FOR COMMERCIAL USE
2
ASSEMBLY-DISASSEMBLY INSTRUCTIONS
IMPORTANT: Juice extractor should be unplugged from outlet when
disassembling.
ASSEMBLING (SEE FIG. 1):
1. To assemble juicing assembly, place bowl on base housing and place spout facing front between the two raised projections.
2. Place basket inside the bowl over the hex nut. Be certain
Juicing Assembly
basket sits at.
3. Place cutter blade inside basket with teeth up.
4. Tighten spring clutch nger-tight or snug.
5. Your juicer includes a 20 pack of lters. Using the lters is optional. If using the lter, insert the lter inside the basket and open the lter so that it covers the inside perimeter of the basket. The lters can be purchased as a 200 pack accessory with model number CAC66. Contact your local Waring dealer for more information or visit www.waringcommercialproducts.com to locate a dealer.
6. Place cover on bowl with feeder chute to right rear and turn it counterclockwise to secure beneath spring clips.
Plunger
Feeder Chute
Cover
Spring Clutch Cutter Blade
Strainer Basket
Bowl
Spout
Spring Clip
Sidearms
Hex Nut
Motor Base Housing
FIG. 1
7. The juice extractor will not operate until the cover is properly assembled in place.
DISASSEMBLING (SEE FIG. 1):
1. With juice extractor facing you (spout front) put your hands on both sides of the cover. Using the sidearms, turn cover clockwise. This will disengage the cover from the spring clips and allow you to lift off the cover.
2. Looking into juice extractor, remove spring clutch by unscrewing counterclockwise.
3. Lift out cutter blade.
4. Lift out strainer basket.
5. Lift off bowl.
3
Loading...
+ 5 hidden pages