Wandboard Solo, Dual User Manual

WANDBOARD USER GUIDE

(20130208)

Page 2 of 13

WANDBOARD DESIGN AND DISCLAIMER

These design materials referred to in this document are *NOT
SUPPORTED* and DO NOT constitute a reference design. Only
"community" support is allowed via resources at Wandboard.org forums.

THERE IS NO WARRANTY FOR THE DESIGN MATERIALS, TO THE EXTENT
PERMITTED BY APPLICABLE LAW. EXCEPT WHEN OTHERWISE STATED IN
WRITING THE COPYRIGHT HOLDERS AND/OR OTHER PARTIES PROVIDE
THE DESIGN MATERIALS "AS IS" WITHOUT WARRANTY OF ANY KIND,
EITHER EXPRESSED OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE
IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE. THE ENTIRE RISK AS TO THE QUALITY AND
PERFORMANCE OF THE DESIGN MATERIALS IS WITH YOU. SHOULD THE
DESIGN MATERIALS PROVE DEFECTIVE, YOU ASSUME THE COST OF ALL
NECESSARY SERVICING, REPAIR OR CORRECTION.

This board was designed as an evaluation and development tool. It was
not designed with any other application in mind. As such, these design
materials may or may not be suitable for any other purposes. If used, the
design material becomes your responsibility as to whether or not it meets
your specific needs or your specific applications and may require changes
to meet your requirements.

Page 3 of 13

Page 4 of 13

Block Diagram

Page 5 of 13

Overview

Wi-Fi chip iMX6 CPU

uFL IPEX connector

for Wi-Fi & Bluetooth Memory

SD-card (OS) Camera header

EDM-Standard

Connector Reset button

Expansion Pin headers

Page 6 of 13

Digital line Out SATA (not populated)

Digital line in Serial

Microphone USB Host

S/PDIF SD-card
(applications)

HDMI

Gigabit LAN

5VDC in USB OTG

Page 7 of 13

Expansion pin headers

Page 8 of 13

Camera header

Page 9 of 13

Quick Start Guide

a) Connect display: use a quality

HDMI cable to connect to your
HDMI TV or Monitor.

b) Connect network: use a standard

RJ45 LAN cable to connect your
wired network (optional)

c) Connect wireless antenna (sold

separately). This option is only
available on Wandboard dual)

d) Connect a standard USB mouse

or keyboard

e) Insert the microSD (orange

microSD card slot)

Read the last 2 pages of this document
to create a microSD card containing
the Operating System.

f) Power up: Plug in a power supply

(5 VDC at 2A is recommended)

(Storage)

(for OS)