Wanco WRDR569 User Manual

OPERATIONS MANUAL

WRDR-L

RADAR HEAD

108569-000

Rev 3/30/07 Manual P/N 108671-001 Wanco Inc.

WRDR-L

RADAR HEAD

THIS UNIT IS FULLY ASSEMBLED AND READY TO USE.

NO CONFIGURATION IS REQUIRED.

Thank you for choosing the Wanco Radar Head. Your radar is in a Polycarbonate enclosure suitable for
outdoor use and is protected against access of oil, dust and water. The radar has been tested to and
complies with FCC part 15 class A. The radar head uses a state of the art modern radar transceiver that
offers excellent range detection without false detecting on spurious electronic signals and no
configuration is required.

SAFETY

Do not look directly into the radar head when it is powered up. Keep any body part away

from the radar beam as much as possible and at a minimum of 20 cm.

Rev 3/30/07 Manual P/N 108671-001 Wanco Inc.

2

FCC/CANADIAN INFORMATION

FCC ID: UQXWRDR569
MODEL: WRDR-L
IC: 6809A-WRDR569

This device complies with Part 15 of the FCC Rules and with RSS-210/Gen of Industry Canada.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause
undesired operation.

Warning: Changes or modifications not expressively approved by the party responsible for compliance
could void the user’s authority to operate the equipment.

The term “IC:” before the radio certification number only signifies that Industry Canada
technical specifications were met.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.

This device must not be co-located or operating in conjunction with any other
antenna or transmitter.

NOTE: This modular transmitter must be labeled with its own FCC ID number, and, if the FCC ID is
not visible when the module is installed on/inside your device, then the outside of the device into which
the module is installed must also display a label referring to the enclosed module. This exterior label
may use wording such as the following: "Contains Transmitter Module FCC ID: UQXWRDR569" or
"Contains FCC ID: UQXWRDR569." Any similar wording that expresses the same meaning may be
used.

Rev 3/30/07 Manual P/N 108671-001 Wanco Inc.

3