Wanco WRDR432 Users Manual

OPERATIONS MANUAL

WRDR

RADAR HEAD

108432-000

WRDR

RADAR HEAD

THIS UNIT IS FULLY ASSEMBLED AND READY TO USE.

NO CONFIGURATION IS NORMALLY NECESSARY

Thank you for choosing the Wanco Radar Head. Your radar is in a Polycarbonate enclosure suitable for
outdoor use and is protected against access of oil, dust and water. The radar has been tested to and
complies with FCC part 15 class A. The radar head uses a state of the art modern radar transceiver that
incorporates a transistor instead of a diode that offers many advantages including reliability.

SAFETY

Do not look directly into the radar head when it is powered up. Keep any body part away

from the radar beam as much as possible.

2

FCC/CANADIAN INFORMATION

FCC ID: UQXWRDR432
MODEL: WRDR
IC: 6809A-WRDR432

This device complies with Part 15 of the FCC Rules and with RSS-210/Gen of Industry Canada.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause
undesired operation.

Warning: Changes or modifications not expressively approved by the party responsible for compliance
could void the user’s authority to operate the equipment.

The term “IC:” before the radio certification number only signifies that Industry Canada
technical specifications were met.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.

This device must not be co-located or operating in conjunction with any other
antenna or transmitter.

3