Wampler Pedals Cranked OD User Manual
TM
Cranked
TM
OD
Cranked OD - 2014 Limited Edition Overdrive
Every since Wampler Pedals discontinued the original version
“Cranked AC” we have been having tons and tons of customer
requests for a re-release of that pedal. While the original sounded
pretty good – Brian knew that he could make it sound great! So after
some tinkering on the breadboard, we are proud to announce the
CRANKED. A pedal truly worthy of its name!
The Cranked picks up where the Thirty Something leaves o. This
pedal is a tribute to those famous British amps that are running wide
open. Whether at bedroom volume or full on stage rock stardom –
you can achieve truly cranked up tones at any time.
After revisiting the original unit, there just had to be some updates.
Starting with an active 3 band EQ. Now you can dial in or take out as
much of each frequency as you want; totally tonal control!
The Cranked is strictly limited edition overdrive – this is your chance
to own a piece of history, with a twist.
Input and Output: The input jack is located on the top right of the pedal, above the treble control and the
output is the other side of the power input, above the bass control.
True By-pass Relay Switch: We use a true-bypass relay because it utilizes a quieter and smoother switch
that is more reliable than traditional bypass switches. Your original tone/signal will remain unaected
when the pedal is not engaged.
Volume: This control adjusts the output level of the Cranked. The Cranked was designed to have higher
output. This allows the Cranked to have more headroom when needed. The output volume, Gain and
Tone controls all have an impact on the total volume, so you might want to adjust the Volume after you
have dialed in the other controls. Re-adjustment might be necessary if you get it to the desired level and
still need to tweak the sound.
Gain: This control adjusts the total amount of gain that is
applied to the signal path. Turning the Gain control clockwise will increase the amount of gain in the circuit.
Bass: Adjusts the amount of bass applied to the eected
signal. If you are using a Stratocaster® style, single coil
guitar rather than a humbucker loaded instrument, you
might nd you need more bass to “fatten” up the tone.
When in the fully counterclockwise position, the tone will
be much thinner and brighter and when fully clockwise it
will be fuller, darker and heavier around the low end.
Mids: Adjusts the total amount of midrange that is applied
to the eected signal. You have total control and can dial
in less or even more mid-range as you see t.
A Kinky tone...
Some say they invented the guitar ri, it really got me going!
Treble: Works in the same way as the bass knob but
controls the amount of treble on the eected signal.
Again, fully counterclockwise the treble is reduced considerably and clockwise brings it forward. You may have to
tweak both the treble and bass controls simultaneously to
nd your sweet spot.
Suggested Settings (volume to suit)
Hero, ghting the Foo.
A post Nirvana tone?
Her Majesty.
A tone so regal, it’s just what the Dr. ordered.
Power Requirements
The pedal can be powered by a 9V battery. The battery terminal is located inside the pedal. If
using a power supply, power needed for the pedal is 9V DC, regulated, center pin negative, as
supplied by most standard Boss™/Ibanez™/Etc. supplies. The pedal can be safely powered with a
multi-supply, like the Visual Sound 1SPOT™. The pedal was designed explicitly around the usage
of a 9V DC power source, and is intended to sound its best at 9V. To avoid damage to the pedal,
do not exceed 9V DC, do not use center pin positive adapters, and do not use AC power. Using an
incorrect power adapter can lead to damage and will void the warranty on the pedal. This pedal
draws 17mA.
Please note: If you are using a battery, it will drain when the input cord is plugged in.
Return and Warranty Policy
For direct sales, there is a 14-day “no questions asked” period where you may return the pedal for any reason, provided that it is in its original condition. Please retain
all packaging within this period in case you decide to return it! We only require that you pay shipping back. The 14 days start when you receive the pedal. This does
not apply to dealer or retailer sales – see their individual return policies for specic information.
All Wampler Pedals, Inc. pedals carry a 5-year, fully transferable warranty that covers defects due to parts and labor. The warranty begins at the point of purchase.
Please remember to register your pedal as soon as possible after purchase at the following web page to ensure quicker service if you should ever need to make a
warranty claim: www.wamplerpedals.com/warranty_registration/
For warranty repairs or questions, please feel free to contact us at www.wamplerpedals.com/contact/
Rory’s ‘61
If this tone had a serial number, it would be 64351.
Any trademarks attributed that are not owned by Wampler Pedals, Inc. are for
demonstrative purposes only, and are property of their respective owners
Loading...