Walrus Audio Voyager User manual
voyager
pre amp/overdrive
9V JACK
9-volt DC, Center Negative,
100ma min.
The Voyager is a gain/preamp overdrive that boasts a full spectrum
of tone from any setting on its simple set of controls. From its
lowest to highest settings, The Voyager provides a uniquely superb
amount of clarity to any style of playing. At lower gain settings,
it brightens the signal and adds clarity to each note played. With
the gain turned up, the Voyager transforms into a thick overdrive,
providing depth to chorded playing while retaining the clarity
needed to break through on solos.
BYPASS LED
Illuminated when the effect is on.
VOLUME
The Volume knob sets the overall
output of the pedal.
TONE
Allows specic adjustment of high
end/treble frequencies. Turn clockwise
to increase amount of high/treble
frequencies introduced into the signal.
Turn counterclockwise to decrease
high/treble frequencies and add low/
bass frequencies into the signal.
OUTPUT JACK
1/4 inch cable to amplier.
GAIN
Adjusts the gain output. As it is
increased, the signal becomes
grittier and more overdriven. As it is
decreased, the signal becomes less
gritty and sounds closer to the original,
unaffected signal.
INPUT JACK
1/4 inch cable from instrument.
BYPASS SWITCH
Turns the effect on and off.
Loading...