Walrus Audio Phoenix User manual

PHOENIX

clean power supply

230 v

The Walrus Audio Phoenix is a 15-Output isolated power supply,

utilizing two internal custom wound toroidal transformers to provide

a high level of noise rejection, giving artists the purest sound in their

signal chain. The Phoenix is housed in a solid die cast enclosure

and is 9.75” long x 2.6” wide x 2” high and has the following outputs

available:

8 - 9V 100mA • 4 - 9V 300mA • 1 - 18V/9V 100mA • 2 - 12V/9V 100mA

The Phoenix comes with a detachable 230V AC power cord. This unit

comes with 15, 2.1mm barrel black power cables and 2 black-to-red

(line 6) power cables.

BACK

FRONT

POWER LED

Illuminated when the

supply is on.

VOLTAGE RATING

The voltage rating for your pedal must be 9VDC (direct current), do not use the
Phoenix for AC (alternating current pedals). Most effects pedals are designed

for 9VDC power, however, you should always check rst or you could risk

destroying your pedal.

POLARITY

For all standard effects pedals with center negative 2.1mm barrels, you can

use the Black-to-Black barrel connectors. Specically, for Line 6 pedals,

you will have to use the Black-to-Red connectors. If you have a question
about the voltage requirement of your pedal or which output to use, email
[e-mail].

230VAC INPUT

Plug male end of included power cord into
a 230VAC power source. Once plugged in,

the LED light will come on indicating that

the power supply is now on.

Flip switch up for 18V, down for 9V.

Flip switch up for 12V,
down for 9V.

CURRENT DRAW

If the current requirement for your pedal is between 100mA - 300mA, you will
need to use the 300mA outputs. For anything less than 100mA, you can use
the 100mA outputs. Note: using the high current output on a low current draw

pedal will work ne and not hurt the pedal. Refer to your pedal’s manual for its
specic requirements.

WARRANTY

The Phoenix comes with a limited lifetime warranty for workmanship and
components. Warranty does not include misuse or accidents resulting in
damage. Warranty is not transferable or assignable and will only be issued
to the original owner. Valid with receipt showing date of purchase. Contact
[e-mail] to receive an RMA number before returning product.

Standard 2.1mm
9VDC plug for
most effects pedals

Standard 2.1mm
9VDC Jack

Negative-to-Ground

AUS UK JAP UK

WARNING

Before connecting your effects pedal to the Phoenix, you must rst verify the

power requirements for your pedal. Input Voltage Requirements - 120V (60Hz).
This product will be destroyed if any other input voltage is used, voiding the
warranty. If the backplate is opened, the warranty is immediately voided. For
repairs, troubleshooting or questions, contact us at [e-mail].

Do not attempt to x defective unit yourself. Contact Walrus Audio at repairs@

walrusaudio.com for help.