JUPITER v2
multi-clip fuzz
9V JACK – 9-volt DC, Center
Negative, <100ma
The Jupiter is a true bypass fuzz pedal inspired by the desire
for gritty, thick and loud fuzz. The Jupiter V2 now features an
added gate control via internal trim pot to tame noise, or to
achieve the spatty “dying battery” tones. Volume and tone
controls have been updated for better control and improved
high frequency response allowing the ability to dial in the
right amount of fuzz with the right tonal quality to either stand
out in the mix, or ride it out with the drums and rhythm. It
includes a Mode switch that changes between three dierent
clipping diode arrangements, providing more options and
combinations of fuzz and tone and a Bass boost toggle switch
for increased low end.
LEVEL
Controls the output level.
MODE
Switches between arrangements
of clipping diodes to create an
assortment of fuzz tones.
OUTPUT JACK
1/4 inch cable to amplier.
FUZZ
Adjusts the fuzz or distortion
output. As it is increased the
signal becomes more distorted
and fuzzy.
TONE – Allows adjustment and
addition of treble frequencies.
BASS CUT – When activated,
cuts the low end/bass. To activate
switch the toggle to the left.
INPUT JACK – 1/4 inch
cable to guitar.
ON/OFF TRUE
BYPASS SWITCH
Press switch to turn on (eect
mode) and again to turn o
(bypass mode).
TRIM POT ADJUSTMENT
Open the pedal’s enclosure and turn upside down. Inside the pedal
you will nd a small blue square with an adjustable screw. Turning
the screw all the way to the left will give the most gated sound. This
is where the “dying battery” eect kicks in. Turning all the way to
the right opens the pedal up and decreases the noise gate.