Walmart WMBR 1 User Manual

Walmart WiFi Bridge

WMBR-1 User Manual

WARNING

 Read, keep and follow these instructions.
 Heed all warnings.
 Clean only with a dry cloth.
 Do not install near any heat sources as radiator, heat registers, stoves and other apparatus (including

Disconnect the power adapter or any other connected peripherals if any of the following conditions exist:

 The power cable or connector is damaged or frayed.


 The WiFi Bridge or attached cables are exposed to rain, water/fluids, or excessive moisture.
 The WiFi Bridge or its power adapter is damaged or has been dropped and you suspect it needs to

WARNING: No user-serviceable parts inside. Refer all servicing to qualified service personnel.

IMPORTANT CONSUMER INFORMATION

amplifiers) that produce heat.

You want to clean the WiFi Bridge

be serviced.

: Please read before activating or using the device.

WARNING: This product contains chemicals known to the State of California to cause cancer and
reproductive toxicity. For more information please call 1-833-235-2111

Information for the user

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:



Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.


Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.



Consult the dealer or an experienced radio/TV technician for help.

Important Note: FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator & your
body.

FCC Caution

Any changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.